Instruction for Use

35
Before contacting the After-Sales Service:
1. Try to resolve the problem yourself (see
“Try to resolve the problem yourself first”).
2. Switch the appliance on and off to see if the
problem is still there. If the problem is still
there, switch the appliance off and switch it
back on again after an hour.
3. If the problem persists, inform the After-
Sales Service:
Please provide the following information:
• Natureofthefault
• Appliancemodel
• Servicenumber(thenumberaftertheword
SERVICE on the specification plate inside
the appliance)
• Yourfulladdress
• Yourtelephonenumberandareacode
Note:
if the door hinge is replaced by the After-
Sales Service, this does not fall under the
guarantee.
AFTER-SALES SERVICE
• Donotinstalltheapplianceclosetoa
heat source. Installation of the appliance
in a warm room, close to sources of heat
(radiators, ovens) or in direct sunlight
increases the power consumption and
should therefore be avoided.
• Ifthisisnotpossible,thefollowingminimum
distances must always be observed:
• 30cmfromcoaloroil-burningstoves;
• 3cmfromelectricand/orgascookers.
• Mountthespacers(ifsuppliedwith
the appliance) on the rear panel of the
condenser on the back of the appliance.
• Installtheapplianceinadryandwell-
ventilated location and level it if necessary
using the adjustable front feet.
• Cleantheinsidecompartment.
• Installtheaccessories.
Electrical connection
• Theelectricalconnectionsmustcomply
with local regulations.
• Informationonthevoltageandpower
consumption is given on the specification
plate inside the appliance.
• The appliance must be grounded
(earthed) by law. The manufacturer is
not liable for any injury to persons or
animals, or damage to property due
to non-compliance with the directions
given above.
• Iftheplugandsocketarenotofthesame
type, have the socket changed by a qualified
electrician.
• Donotuseextensionleadsormultiple
adapters.
Electrical disconnection
It must be possible to disconnect the appliance
by disconnecting the plug from the mains
supply or via an upstream two-pin switch.
INSTALLATION