Operating Instructions HOB Contents GB English,1 RS , 11 Installation, 2-5 Positioning Electrical connection Gas connection Data plate Burner and nozzle specifications Description of the appliance, 6 Overall view Start-up and use, 7 Practical advice on using the burners Precautions and tips, 8 General safety Disposal 7HPZ 750 R GH RU/HA Maintenance and care, 9 Switching the appliance off Cleaning the appliance Gas tap maintenance Troubleshooting, 10 GB
Installation ! Before operating your new appliance please read this instruction booklet carefully. It contains important information for safe use, installation and care of the appliance. also be equipped with vents to allow gas to escape in the event of a leak. As a result LPG cylinders, whether partially or completely full, must not be installed or stored in rooms or storage areas that are below ground level (cellars, etc.).
temperatures higher than 50°C. Front GB ! The installer must ensure that the correct electrical connection has been made and that it is compliant with safety regulations. Before connecting to the power supply, make sure that: • The appliance is earthed and the plug is compliant with the law. Hooking position for top H=40 mm • The socket can withstand the maximum power of the appliance, which is indicated on the data plate.
GB These pipes must be installed so that they are never longer than 2000 mm when fully extended. Once connection has been carried out, make sure that the flexible metal pipe does not touch any moving parts and is not compressed. • Setting the burners to minimum: 1. Turn the tap to the low flame position. 2. Remove the knob and adjust the adjustment screw, which is positioned in or next to the tap pin, until the flame is small but steady.
Burner and nozzle specifications GB Table 1 Liquid Gas Burner Diameter Thermal (mm) power kW (p.c.s.* Natural Gas Thermal power kW (p.c.s.*) By-Pass 1/100 Nozzle 1/100 Ridot. Nomin. (mm) (mm) *** Flow* g/h Thermal power kW (p.c.s.*) Nozzle 1/100 Flow* Nozzle Flow* l/h 1/100 l/h ** Nomin.
Description of the appliance GB Overall view GAS BURNERS Support Grid for COOKWARE Control Knobs for GAS BURNERS SAFETY DEVICES* • GAS BURNERS differ in size and power. Use the diameter of the cookware to choose the most appropriate burner to cook with. • Control Knobs for GAS BURNERS adjust the power or the size of the flame. • GAS BURNER ignition* enables a specific burner to be lit automatically. • SAFETY DEVICE* stops the gas flow if the flame is accidentally extinguished.
Start-up and use ! The position of the corresponding gas burner is shown on every knob. • Gas burners Each burner can be adjusted to one of the following settings using the corresponding control knob: Inner ring set to minimum To switch from using the inside ring on its minimum setting to using both rings, press and turn the knob anti-clockwise until it has gone beyond the tap stop position.
Precautions and tips GB ! This appliance has been designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. General safety • This is a class 3 built-in appliance. • Gas appliances require regular air exchange to maintain efficient operation. When installing the hob, follow the instructions provided in the paragraph on “Positioning” the appliance.
Maintenance and care Switching the appliance off Gas tap maintenance Disconnect your appliance from the electricity supply before carrying out any work on it. Over time, the taps may become jammed or difficult to turn. If this happens, the tap must be replaced. Cleaning the appliance ! This procedure must be performed by a qualified technician authorised by the manufacturer.
Troubleshooting GB It may happen that the appliance does not function properly or at all. Before calling the service centre for assistance, check if anything can be done. First, check to see that there are no interruptions in the gas and electrical supplies, and, in particular, that the gas valves for the mains are open. Problem Possible causes/Solution The burner does not light or the flame is not even around the burner. • The gas holes on the burner are clogged.
RS RS
! ! !
!
RS !
Таблица 1 Горелка 100 75 51 30 Тепловая мощность кВт (p.c.s.*) Сокращенная 0,70 0,40 0,40 0,30 Тепловая м ощность кВт (p.c.s.
RS
! RS
RS !
!
RS 06/2010 - 195084557.