Setup and user guide

EN
3
DAILY USE
FUNCTIONS
ALARM TABLE
ON/STANDBY FUNCTION
To put the product in Stand-by, press and hold the On/Stand By
button for 3 seconds. All the indicators turn o except On/Standby
indicator.
Press again to reactivate the appliance.
TEMPERATURE SETTING
Press the Temperature button on the control panel to
adjust the temperature from the warmest through the
lower to the coldest level.
Pressing the Temperature button, the temperature setting
will change cyclically.
At rst plug-in of appliance temperature setpoint is present
at medium position (factory setting).
Following table shows temperature setpoints:
HIGH TEMP.
MEDIUM TEMP.
LOW TEMP.
MED-HIGH TEMP.
MED-LOW TEMP.
FAST COOLING
Led on Led o
Note: Displayed set points correspond to the average
temperature throughout the whole refrigerator.
6TH SENSE FRESH CONTROL
This function automatically works to ensure the optimal
conditions to preserve the stored food.
See Use and Care Guide for more details on functions /
see last page for information on how to obtain the Use and Care Guide
FAST COOLING FUNCTION
The use of the Fast Cooling function is recommended to
increase the cooling/freezing capacity of the refrigerator/freezer
compartment when placing a very high quantity of food within it.
To activate the Fast Cooling function, press the
Temperature button cyclically on the control panel till all
the 3 LEDs blink and remain on.
The function is automatically deactivated after 12 hours and
return to previous selected set point.
The function can be manually deactivated by pressing the
Temperature button on the control panel.
REFRIGERATOR LIGHT
The light system inside the refrigerator compartment uses
LEDs light, allowing a better lightning as well as a very low
energy consumption.
If the LED light system does not work, please contact the
Service to replace it.
Important: The refrigerator compartment light switches on
when the refrigerator door is opened. If the door is kept open for more
then 4 minutes the light will be automatically
switched o.
FAN + ANTIBACTERIAL FILTER
The Fan improves temperature
distribution inside the refrigerator
compartment, allowing better reservation
of stored food.
If the appliance has the Fan it can be
equipped with the antibacterial lter.
Remove it from the box placed in the
crisper drawer and insert into the fan cover
- as in the picture.
The replacement procedure is included in the lter box.
ALARM TYPE SIGNAL CAUSE CURE
Door open alarm Refrigerator Light blinks. The door has remained open for
more than 3 minutes.
Close the door
Door open alarm Refrigerator Light OFF The door has remained open for
more than 4 minutes.
Close the door
Malfunction Any temperature indicators
blinks
Product malfunction. Contact the After-sales Service