Instruction for Use

GB
13
DOOR REVERSAL
Warning: Before attempting to remove the doors, switch off the electrical supply and pull out the mains plug.
It is recommended that you remove any loose items/fittings from inside the appliance and place food into insulated
containers whilst carrying out this operation.
You may require assistance to carefully lay the appliance onto its back onto suitable protective materials (i.e. original
packaging).
Remove the doors
1. Lay down the appliance on its back.
2. Unscrew, remove and retain the bottom hinge.
3. Slightly open the bottom door and slide downward remove and carefully place to one side
4. Remove centre hinge and spacer if fitted. Slightly open the top door and slide downwards, remove and carefully
place to one side.
5.“The pin will be
removed and fixed to
the opposite side.”
6. Use a thin blunt
instrument to remove
the top and bottom
hinge bushes and
blanking plugs from
the doors, take care
not to mark the door
handle. Reposition
the blanking plugs
and bushes on the
opposite side.
7. Fit the blanking plugs
provided into the right
hand two centre hinge
holes.
Replacing the doors
1. Slide the top door upwards and locate the top hinge pin into the door bush. Reposition the centre hinge on the
opposite side.
2. Carefully slide bottom door
upward into the centre hinge pin.
3. Unscrew the bottom hinge pin and
refit it on the opposite side..
4. Fit the bottom hinge making sure
that the door is aligned to the
cabinet.
5. Carefully stand the appliance
upright in it’s required location
and make sure it is sitting level
on the floor. Open and close the
doors checking that the gasket
makes a good seal without any
gaps when the doors are closed.
Note: Replace loose items/fittings
back into the appliance and leave
for at least 15 minutes before
switching back on.
2
3
1