Instruction for Use

- 29 -

Fig. A

Fig. B

Fig. C

Fig. D

Connecting the supply cable to the electricity mainsConnecting the supply cable to the electricity mains

Connecting the supply cable to the electricity mains

Find a plug that is suitable for the load indicated on the data plate and fit it onto the cable. The appliance must be directly

connected to the mains using an omnipolar circuit-breaker with a minimum contact opening of 3 mm installed between the

appliance and the mains. The circuit-breaker must be suitable for the load indicated and must comply with current electrical

regulations (the green and yellow earthing wire must not be interrupted by the circuit-breaker). The supply cable must not be

placed in areas where it could reach temperatures higher than 50°C.

Before connecting the appliance to the power supply, make sure that:

• The modulating valve and the electricity supply can withstand the maximum power of the appliance (see the data

plate for details);

• The supply system is earthed correctly, in compliance with current laws and regulations;

• The power socket or omnipolar circuit-breaker may be reached easily once the appliance has been installed.

Installation instructions

230V 1N~

H07RN-F 3x4 CEI-UNEL 35364

NL2L1

400V 2N~

H05RR-F 4x2.5 CEI-UNEL 35363

NL3L1L2

400V 3N~

H05RR-F 5x2.5 CEI-UNEL 35363