Instruction for Use

ManualsBrandsIndesit ManualsDomestic AppliancesCI6V E97 A1 (X) /HA

! Please keep this instruction booklet in a safe place for

future reference.. Make sure the booklet remains with the

appliance if it is sold, given away or moved.

! Please read this manual carefully: it contains important

information on installation, operation and safety.

! The appliance must be installed by a quali ed professional

in accordance with the instructions provided.

! Any necessary adjustment or maintenance must be

performed after the cooker has been disconnected from

the electricity supply.

Positioning and levelling

! The appliance may be installed alongside any cupboards

whose height does not exceed that of the hob surface.

! Make sure that the wall which is in contact with the back

of the appliance is made from a non- ammable, heat-

resistant material (T 90°C).

To install the appliance correctly:

• Place it in the kitchen, the dining room or the studio  at

(not in the bathroom).

• If the top of the hob is higher than the cupboards, the

appliance must be installed at least 600 mm away from

them.

• If the cooker is installed underneath a wall cabinet, there

must be a minimum distance of 420 mm between this

cabinet and the top of the hob.

This distance should be increased to 700 mm if the wall

cabinets are  ammable (see  gure).

• Do not position blinds behind the cooker or less than

200 mm away from its

sides.

• Any hoods must be

installed in accordance

with the instructions listed

in the relevant operating

manual.

Levelling

If it is necessary to level the

appliance, screw the adjustable

feet into the positions provided

on each corner of the base of the

cooker (see  gure).

The legs*  t into the slots on the

underside of the base of the cooker.

Electrical

connection

Fitting the power supply

cable

To open the terminal

board:

• Insert a screwdriver

into the side tabs of the

terminal board cover.

• Pull the cover to open it.

To install the cable, follow the instructions below:

• Loosen the cable clamp screw and the wire contact

screws.

! The jumpers are pre-set at the Factory for 230 V single-

phase connection (see  gure).

230V ~

H05RR-F 3x4 CEI-UNEL 35363

H05VV-F 3x4 CEI-UNEL 35746

• To carry out the electrical connections as shown in the

 gures, use the two jumpers inside the box (see  gure -

labelled “P”).

Installation

HOOD

420

Min.

min.

650

mm. with hood

min.

700

mm. without hood

mm.

600

Min. mm.

420

Min. mm.