Instruction for Use

16
EN
Special wash cycles
and Options
Wash options*
The OPTIONS may only be set, changed or reset after the
wash cycle has been selected and before the Start/Pause
button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle (see Table of wash cycles) , the
corresponding symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch off,
while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press the
corresponding button again.
Multi-functional tablets Option (Tabs)
This option optimises washing and drying results.
When using multi-functional tablets, press the MULTI-
FUNCTIONAL TABLETS button; the corresponding symbol
will light up. If the button is pressed again, the option will be
deselected.
The “Multi-functional tablets” option results in a longer
wash cycle.
Delayed start Option
It is possible to delay the start time of the cycle by a
period of time between 1 and 24 hours:
1. Select the desired wash cycle and any other options required;
press the DELAYED START button. The indicator light will go
on. Use the same button to select when the wash cycle will start
(h01, h02 etc.)
2. Confirm the selection using the START/PAUSE button to start
the countdown.
3. Once this time has elapsed, the DELAYED START indicator
light goes off and the wash cycle begins.
To deselect the DELAYED START option, press the DELAYED
START button until the text OFF appears.
The Delayed Start function cannot be set once a wash cycle
has started.
Half Load Option
If there are not many dishes to be washed, a half
load cycle may be used in order to save water, electricity
and detergent.
The amount of detergent can be halved.
Make sure the crockery and items are dishwasher-safe.
Notes:
Optimum performance levels when using the “Sixty” and “Rapid
30’” cycles can be achieved by respecting the specified number
of place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
[e-mail]