Setup and user guide

4
OPTIONS AND FUNCTIONS
OPTIONS can be selected directly by pressing the corresponding button (see CONTROL PANEL).
If an option is not compatible with the selected program see PROGRAMS TABLE, the corresponding LED ashes rapidly 3 times
and beeps will sound. The option will not be enabled.
HALF LOAD using the upper or lower rack
If there are not many dishes to be washed, a half load
cycle may be used in order to save water, electricity
and detergent. Select the wash cycle and then press
the HALF LOAD button: the indicator corresponding
to the chosen rack lights up and the wash cycle starts
only in the upper or lower rack.
Remember to load the upper or lower rack only,
and to reduce the amount of detergent accord-
ingly.
TABLET
This setting allows you to optimize the performance of
the program according to the type of detergent used.
Press the TABLET button (the corresponding indicator
light will light up) if you use combined detergents in
tablet form (rinse aid, salt and detergent in 1 dose).
If you use powder or liquid detergent, this option
should be o.
PUSH & GO
Push&Go button is an easily distinguishable button
that allows you direct access to the Push&Go program,
a wash and dry cycle that ensures great cleaning
performance in a short time. You don’t have to worry
which program to choose, Push&Go cycle will do the
work for you.
OPERATION INDICATOR
A LED light projected on the oor indicates that the
dishwasher is working. One of the following operating
modes can be selected:
a) Disabled function.
b) When the cycle starts the light goes on for few
seconds, stays o during the cycle and ashes at the
end of the cycle.
c) The light stays on during the cycle and ashes at the
end of the cycle (default mode).
If the delayed start was set, the light goes on either
for the rst few seconds or the entire duration of the
countdown, based on whether mode b) or c) was set.
The light goes o every time the door is opened. To
select the mode you prefer, switch on the machine, hold
down button P until one of the three letters appears on
the display, press button P until you reach the desired
letter (or mode), hold down button P to conrm the
selection.
DELAY
The start time of the program may be delayed for a
period of time between 1 and 12 hours.
1. Press the DELAY button: the corresponding «h»
symbol appears on the display; each time you press
the button, the time (1h, 2h, etc. up to max. 12h) from
the start of the selected wash cycle will be increased.
2. Select the wash program, press the Start/Pause button
and within 4 seconds close the door: the timer will begin
counting down.
3. Once this time has elapsed, the indicator light «h»
switches o and the wash cycle begins.
To adjust the delay time and select a shorter period
of time, press the DELAY button. To cancel it, press
the button repeatedly until the selected delayed start
indicator light «h» switches o.
The Delay function cannot be set once a wash cycle
has been started.
EXTRA
EXTRA makes it possible to carry out a heavy-duty
wash cycle of large crockery up to a max height of 53
cm: baking pans, oven grids, dripping pans, hob grids,
large saucepans, serving dishes, pizza dishes, stainless-
steel hood lters.
Remove the upper rack to load bulky crockery.
Release the two locks (right
and left) and pull out the
rack.
When the upper rack is
tted, the locks must be
always closed.
In order for the water
to reach the crockery
everywhere, arrange it as
shown in the Figure.
Do not start the dishwasher without the upper rack
using wash cycles other than EXTRA.
To carry out the wash cycle Extra pour the detergent
DIRECTLY INTO THE TUB and not into the dispenser.