Instruction for Use

4
GB
There is an adjustable L-shaped pipe fitting on the
appliance supply ramp and this is fitted with a seal in
order to prevent leaks. The seal must always be
replaced after rotating the pipe fitting (the seal is
provided with the appliance). The gas supply pipe
fitting is a threaded 1/2 gas cylindrical male
attachment.
Connecting a flexible jointless stainless steel
pipe to a threaded attachment
The gas supply pipe fitting is a threaded 1/2 gas
cylindrical male attachment.
These pipes must be installed so that they are never
longer than 2000 mm when fully extended. Once
connection has been carried out, make sure that the
flexible metal pipe does not touch any moving parts
and is not compressed.
 Only use pipes and seals that comply with current
National regulations.
Checking the tightness of the connection
 When installation has been completed, check the
pipe fittings for leaks using a soapy solution. Never
use a flame.
DATA PLATE
Dimensions
width 43.5 cm
hei
g
ht 31 cm
de
p
th 43.5 cm
Volume
58 l
This a
pp
liance conforms to the
followin
g
Euro
p
ean Economic
Communit
y
directives:
2006/95/EEC dated 12/12/06
(Low Volta
g
e) and subse
q
uent
amendments - 89/336/EEC dated
03/05/89 (Electroma
g
netic
com
p
atibilit
y
) and subse
q
uent
amendments - 93/68/EEC dated
22/07/93 and subse
q
uent
amendments. 90/336/EEC dated
29.06.90 (Gas) and subse
q
uent
amendments.
2002/96/EC
Burner and Nozzle specifications
Table 1 Liquid gas
Burner By-pass
1/100
Nozzle
1/100
Flow*
g/h
(mm) Nominal Reduced
Oven 49 78 185 65
Supply pressures
Nominal (kPa)
Minimum (kPa)
Maximum (kPa)
30
25
35