Instruction for Use

GB
37
Automatic cleaning by PYROLYSIS
The cleaning cycle can cause the internal temperature of the oven to reach
500°C. The pyrolytic cycle is activated, burning away food and grime residues.
Dirt is literally incinerated.
Keep children away from the appliance during the automatic cleaning cycle
as surfaces may become very hot. Particles may ignite inside the oven as a
result of the combustion process. There is no cause for concern: this process
is both normal and hazard-free.
Before initiating the PYROLYTIC cycle:
• clean the oven door;
• remove large or coarse food residues from the inside of the oven using a
damp sponge. Do not use detergents;
• remove all accessories and the sliding rack kit (where present);
• do not place tea towels or pot holders over the oven handle.
! If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven to
cool down.
! The programme may only be started once the oven door has been closed.
To activate the cleaning cycle :
1. Press to switch on the control panel.
2. Press the icon.
3. Scroll through the menu commands using the control dial, select
PYROLYTIC and press .
4. The appliance suggests a “NORMAL” pyrolytic cycle, with a duration of 1
hour 30 minutes. Other levels of cleaning may be selected.
• Use the control dial to select one of the following:
- “ECONOMY”: duration 1 hour
- “NORMAL”: duration 1 hour and 30 minutes
- “INTENSIVE”: duration 2 hours.
• Press again.
5. Press to begin the PYROLYTIC cycle.
Safety devices
• the door locks automatically as soon as the temperature reaches a high
value; the icon lights up on the display.
• pressing the icon cancels the cleaning cycle at any time.
• if a malfunction occurs, the heating elements will be switched off.
• once the oven door has been locked, you cannot change the duration and
end time settings.
Programming delayed automatic cleaning
! Programming is possible only after selecting the cleaning cycle.
1. Press the icon twice; the end of pyrolysis time will begin to ash.
2. Turn the control dial to adjust the end of pyrolysis time; hold the dial in this
position to scroll through the numbers more quickly and make the setting
process easier. The display will show a graphic indicating the delayed start
in bar format.
3. Once you have reached the desired end time, press the icon again.
The delayed start bar will show the current time, the time remaining until the
start of pyrolysis, the duration and the end of pyrolysis time as a graphic.
4. Press to begin the pyrolysis schedule.
5. The display shows the remaining time, moving the delayed start bar
backwards.
6. Once pyrolysis has begun, the display will indicate the remaining time by
lling the duration bar.
7. When the time has elapsed, “CLEANING CYCLE FINISHED” appears on
the display and a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy PYROLYTIC cycle has been
selected: default set time 1 hour. 12:30 is scheduled as the end time. The
programme will start automatically at 11:30 a.m.
To cancel a schedule, press the icon.
Once the automatic cleaning cycle is over
Before you can open the oven door, you will have to wait for the icon to
switch off: this indicates the oven temperature has dropped to an acceptable
level. You will notice some white dust deposits on the bottom and the sides
of your oven; remove these deposits with a damp sponge once the oven
has cooled down completely. Alternatively, you can make use of the already
heated oven, in which case it is not necessary to remove the deposits, they
are completely harmless and will not affect your food in any way.