Instruction for Use

12
GB
Installation
 Before operating your new appliance please read this
instruction booklet carefully. It contains important information
concerning the safe operation, installation and maintenance of
the appliance.
 Please keep these operating instructions for future reference.
Pass them on to possible new owners of the appliance.
Positioning
 Keep all packaging materials out of the reach of children. It
may present a choking or suffocation hazard (see Precautions
and tips).
 The appliance must be installed by a qualified professional in
accordance with the instructions provided. Incorrect installation
may damage property or cause harm to people or animals.
Built-in appliance
Use the appropriate cabinet to ensure that the appliance
functions properly.
 The supporting surface must be heat-resistant up to a
temperature of approximately 100°C.
 If the appliance is to be installed above an oven, the
oven must have a forced ventilation cooling system.
 Avoid installing the hob above a dishwasher: if this
cannot be avoided, place a waterproof separation
device between the two appliances.
 Depending on the hob you want to install, the cabinet
must have the following dimensions (see figure):
Ventilation
To allow adequate ventilation and to avoid overheating of
the surrounding surfaces the hob should be positioned as
follows:
 At a minimum of 40 mm
from the back panel and
600 mm from any other
vertical surfaces.
 So that a minimum
distance of 10 mm is
maintained between the
installation cavity and the
cabinet underneath.
Fixing
The appliance must be installed on a perfectly level
supporting surface.
Any deformities caused by improper fixing could change
the features and the operation of the hob.
40 mm
10
mm
560 +/- 1
490 +/- 1
48
590
520
560 +/- 1
490 +/- 1
48
574
504
10 mm
Distance to
keep between the
cut-out slot and
the cabinet
FRONT OF HOB
KITCHEN
WORKTOP
30
40
REAR SPRING ASSEMBLY
HOB FROM BELOW
40 mm min.
40mm
Opening of at least 5 mm
on the overall width
measurement of the surface.
Above an empty cabinet or a drawer
A space of at least 40 mm, or an opening of 5 mm on
the width measurement of the cabinet, should be created.
690
520
560 +/- 1
490 +/- 1
48
785
750 +/- 1
510
490+/- 1
48