Instruction for Use
16
GB
Start-up and use
When the hob is plugged in, all the indicator lights
on the control panel light up for a few moments and
there will be a short acoustic signal. Subsequently,
the control panel switches off and, at this point, it
will be possible to switch the hob on.
Switching the hob on
To switch on the hob, hold the button down for
approximately 1 second.
Cooking zone operation
Each cooking zone is activated by means of a
power adjustment device which is made up of a
double key (+,-).
Switching on a cooking zone
To switch on a cooking zone, set the desired
power using the
+ +
+ +
+ and - keys.
To set the maximum temperature directly, briefly
press the
- -
- -
- key
..
..
.
Extendable cooking zone operation
(if the hob comes with extendable cooking zones,
see previous page)
1.1.
1.1.
1.
Double plate;Double plate;
Double plate;Double plate;
Double plate;
a. set the desired power using the
+ +
+ +
+ and
--
--
-
keys (the innermost cooking zone is activated).
b. if the cooking zone is circular: press
to
enable/disable the outermost cooking area
b. if the cooking zone is oval: press
to
enable/disable the extendable cooking area
Switching off a cooking zone
To switch off a cooking zone:
press thekeys
+ +
+ +
+ and
- -
- -
- simultaneously: the
power immediately returns to 0 and the cooking
zone switches off;
or press the
- -
- -
- key: the cooking zones power
decreases progressively until it switches off.
Switching off the hob
Press the appliance switches off.
If the hobs controls have been locked (see previous
paragraph), they will continue to be locked even
after the hob has been switched back on. To switch
the hob back on, it is necessary to unlock the
controls.
Locking the controls
When the hob is operating, it is possible to block
the controls to prevent the settings from being
accidentally modified (children, cleaning operations,
etc.).
All you have to do is press
; the indicator light
above the key lights up and
the controls arethe controls are
the controls arethe controls are
the controls are
lockedlocked
lockedlocked
locked.
To modify the heating power or to interrupt the
cooking process, it is necessary to unlock the
controls: press
for a few moments; the indicator
light goes off and
the controls unlockthe controls unlock
the controls unlockthe controls unlock
the controls unlock..
Programming the cooking time
It is possible to programme all the cooking zones for
a duration of between 1 and 99 minutes. Proceed as
follows:
set the desired power on the plate/s using the
++
++
+
and
- -
- -
- keys;
press the programming key until the indicator
light in the position corresponding to the plate
that you intend to programme lights up;
set the desired cooking time using the
+ +
+ +
+ and
--
--
-
keys
;
to confirm the programme
a. press
again
b. wait approximately 10 seconds without
pressing any other keys.
The cooking time countdown begins immediately.
The end of the programmed cooking time is
indicated by means of an acoustic signal (this lasts
for 10 seconds) and the cooking zone switches off.
Repeat the above-mentioned procedure for each
plate that you intend to programme.
Programmed time display
If one or more plates have been programmed, the
display shows the time remaining for the plate which
is closest to the end of the programmed time,
indicating its position by means of the
corresponding indicator light, which will be on. The
indicator lights that correspond to the other
programmed plates will flash.
To show the time remaining for the other
programmed plates, press
repeatedly; the times
of all the programmed plates will be shown in
sequence, in an anticlockwise direction, beginning
from the front left one (only the corresponding
indicator light will be on and the display flashes)