LH8 XXXX X LH8 XXXX XX English Operating Instructions REFRIGERATOR/FREEZER COMBINATION Contents Operating Instructions, 1 Assistance, 2 Description of the appliance, 3 Description of the appliance, 4 Installation, 5 Start-up and use, 5 Maintenance and care, 6 Precautions and tips, 7 Troubleshooting, 7 Reversible doors, 9
Assistance Before calling for Assistance: • Check if the malfunction can be solved on your own (see Troubleshooting). • If after all the checks, the appliance still does not operate or the problem persists, call the nearest Service Centre Communicating: • type of malfunction • appliance model (Mod.) • serial number (S/N) This information can be found on the data plate located on the bottom left side of the refrigerator compartment.
Description of the appliance Control panel 1. ON/OFF The whole product (both fridge and freezer compartments) can be turned on by pressing this button for 2 seconds. The last set value is indicated on the interface. Press this button to turn off the device. An audible signal will confirm the “off commutation of the product”. 2. FRIDGE temperature indicator It shows the temperature of the fridge compartment. 3.
Description of the appliance Overall view The instructions contained in this manual are applicable to different model refrigerators. The diagrams may not directly represent the appliance purchased. For more complex features, consult the following pages. 1 Levelling FEET 2 STORAGE compartment* 3 FREEZER and STORAGE compartment 4 FRUIT and VEGETABLE bin * 5 MULTI USE DRAWER Container* 6 Control panel 7 WINE RACK * 8 SHELVES * 9 LAMP (see Maintenance).
Installation Start-up and use ! Before placing your new appliance into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. ! Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. Starting the appliance Positioning and connection Positioning 1. Place the appliance in a well-ventilated humidity-free room. 2.
GB 2. If the word “OK” does not appear it means that the temperature is too high:set the FRIDGE TEMPERATURE on a colder value, and then wait 10 hours until the temperature becomes stable. 3. Check the indicator light again: if necessary, readjust it following the initial process. If large quantities of food have been added or if the refrigerator door has been opened frequently, it is normal for the indicator not to show OK. Wait at least 10 hours before you set the FRIDGE temperature on a colder value.
Replacing the light bulb * To replace the light bulb in the refrigerator compartment, pull out the plug from the electrical socket. Follow the instructions below. Access the light bulb by removing the cover as indicated in the diagram. Replace it with a similar light bulb within the power range indicated on the cover. 3 Precautions and tips ! The appliance was designed and manufactured in compliance with international safety standards.
GB The motor runs continuously. • The SUPER button was pressed: the yellow SUPER indicator is on (see Description). • The door is not closed properly or is continuously opened. • The outside ambient temperature is very high. The appliance makes a lot of noise. • The appliance has not been installed on a level surface (see Installation). • The appliance has been installed between cabinets that vibrate and make noise. • The internal refrigerant makes a slight noise even when the compressor is off.
Reversible doors 400011210865 12/2017 9