Setup and user guide

2
DAILY USE
FUNCTIONS
TEMPERATURE SETTING
Press the Temperature button on the control panel to
adjust the temperature from the warmest through the lower
to the coldest level.
Pressing the Temperature button, the temperature
setting will change cyclically. At rst plug-in of appliance
temperature setpoint is present at medium position (factory
setting).
Following table shows temperature setpoints:
HIGH TEMP.
MEDIUM TEMP.
LOW TEMP.
MED-HIGH TEMP.
MED-LOW TEMP.
SUPER COOL
Led on Led o
Note: Displayed set points correspond to the average
temperature throughout the whole refrigerator.
SUPER COOL
The use of the Super Cool function is recommended
to increase the cooling capacity of the refrigerator
compartment when placing a very high quantity of food
within it. To activate the Super Cool function, press and hold
for 3 seconds the Temperature button on the control panel
till all the 3 LEDs will turn on.
FIRST TIME USE
HOW TO START THE APPLIANCE
After plugging the appliance to the mains, it starts the
operation automatically. After starting the appliance, wait at
least 4-6 hours before placing food into the fridge and into
the freezer compartment.
When the appliance is connected to the power supply, the
display lights up and all the icons appear on the display for
approximately 1 second. The default (factory) values of the
fridge compartment settings light-up.
ACCESSORIES
See Use and Care Guide for more details on functions / see last
page for information on how to obtain the Use and Care Guide
The function is automatically deactivated after 24 hours and
return to previous selected set point.
!
!
!
The function can be manually deactivated by pressing and
holding for 3 seconds the Temperature button on the control
panel.
REFRIGERATOR LIGHT
The light system inside the refrigerator compartment uses
LEDs light, allowing a better lightning as well as a very low
energy consumption.
If the LED light system does not work, please contact the
Service to replace it.
Important: The refrigerator compartment light switches
on when the refrigerator door is opened. If the door is kept
open for more then 8 minutes the light will be automatically
switched o.
FAN
The Fan improves temperature distribution inside the
refrigerator compartment, allowing better preservation of
stored food. By default, the fan is switched on.
To turn o the fan press the button of fan.
Please note that when the fan is switched on it will not
continuously work. The fan will start/stop working depending
on the temperature and/or humidity level inside the fridge.
It is therefore absolutely normal if the fan does not move even
if the fan is switched on.
ALARM TABLE
EGG TRAY BOTTLE SEPARATOR (IF PRESENT) ICE TRAY
ALARM TYPE SIGNAL CAUSE CURE
Door open alarm Refrigerator Light blinks The door has remained open
for more than 5 minutes.
Close the door
Door open alarm Refrigerator Light OFF The door has remained open
for more than 8 minutes.
Close the door
Malfunction Any temperature indicators
blinks
Product malfunction. Contact the After-sales Service