PH 941MSTV (IX) SA EN English Operating Instructions HOB Contents Operating Instructions,1 Warnings,2 Assistance,2 Description of the appliance,3 Installation,4 Start-up and use,8 Precautions and tips,9 Maintenance and care,9 Troubleshooting,10
EN EN Warnings Assistance WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoid touching heating elements. Children less than 8 years of age shall be kept away unless continuously supervised.
EN Description of the appliance Overall view 1. Support Grid for COOKWARE 2. GAS BURNERS 3. Control Knobs for ELECTRIC HOTPLATES*/COOKTOP BROILER*/ CERAMIC GLASS MODULE* 4. Control Knobs for GAS BURNERS 5. Indicator light for ELECTRIC HOTPLATES*/COOKTOP BROILER*/ CERAMIC GLASS MODULE* 6. ELECTRIC HOTPLATES*/COOKTOP BROILER*/CERAMIC GLASS MODULE* 7. Ignition button for GAS BURNERS* 8. Ignition for GAS BURNERS* 9.
! Before operating your new appliance please read this instruction booklet carefully. It contains important information for safe use, installation and care of the appliance. ! Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. Positioning ! Keep packaging material out of the reach of children. It can become a choking or suffocation hazard (see Precautions and tips).
Ventilation To ensure adequate ventilation, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x 560 mm (see diagrams). 560 mm . 45 m m. Where a hob is installed above an oven without a forced ventilation cooling system, adequate ventilation must be provided inside the cabinet by means of air holes through which air can pass (see figure).
GB • Setting the burners to minimum 1. Turn the tap to the low flame position; 2. Remove the knob and adjust the adjustment screw, which is positioned in or next to the tap pin, until the flame is small but steady. 3. Having adjusted the flame to the required low setting, while the burner is alight, quickly change the position of the knob from minimum to maximum and vice versa several times, checking that the flame does not go out. 4. Some appliances have a safety device (thermocouple) fitted.
INJECTORS TABLE Type of gas used Type of burner Injector marking (1/100) Rated consumption Rated heat capacity Gas pressure mm g/h g/h kPa Reduced Rapid (RR) Semi-rapid (S) Auxiliary (A) Triple Crown (TC) 71S 57M 43H2 73F4 189 120 73 236 45 25 25 80 5.0 Type of gas used Model configuration 4 BURNERS Total rated consumption LPG 5.
GB Start-up and use C. Indicator light to show when the cooking zone is above 60°C, even after the heating element has been turned off. ! The position of the corresponding gas burner or electric hotplate* is shown on every knob. B A C Gas burners Each burner can be adjusted to one of the following settings using the corresponding control knob: When the knob is on any of the settings other than “Off”, the Indicator Light for Ceramic Glass Module comes on.
Precautions and tips ! This appliance has been designed and manufactured in compliance with international safety standards. The following warnings are provided for safety reasons and must be read carefully. General safety • This is a class 3 built-in appliance. • Gas appliances require regular air exchange to maintain efficient operation. When installing the hob, follow the instructions provided in the paragraph on “Positioning” the appliance.
400011208387 12/2017 - XEROX FABRIANO GB Periodically, special products will need to be used to clean the surface. First, remove all food buildup or grease with a cleaning scraper, e.g. (not supplied). Clean the cooking surface when it is still warm with a suitable cleaning product (such as the one in the Solutions product line available from any After-Sales Service Centre) and paper towels. Then rub with a damp cloth and dry.