Instruction for Use
GB
7
Connecting the supply cable to the mains
Install a standardised plug corresponding to the load indicated on the data
plate (see table). The appliance must be directly connected to the mains
using an omnipolar switch with a minimum contact opening of 3 mm installed
between the appliance and the mains. The switch must be suitable for the
charge indicated and must comply with current electrical regulations (the
earthing wire must not be interrupted by the switch). The supply cable must
be positioned so that it does not come into contact with temperatures higher
than 50°C at any point (the back panel of the oven, for example).
! The installer must ensure that the correct electrical connection has been
performed and that it is fully compliant with safety regulations.
Before connecting the appliance to the power supply, make sure that
• The appliance is earthed and the plug is compliant with the law.
• The socket can withstand the maximum power of the appliance, which is
indicated on the data plate.
• The voltage is in the range between the values indicated on the data plate.
• The socket is compatible with the plug of the appliance. If the socket is
incompatible with the plug, ask an authorised technician to replace it. Do
not use extension cords or multiple sockets.
! Once the appliance has been installed, the power supply cable and the
electrical socket must be easily accessible.
! The cable must not be bent or compressed.
! The cable must be checked regularly and replaced by authorised technicians
only (see Assistance).
! The manufacturer declines any liability should these safety measures
not be observed.
APPLIANCE SPECIFICATIONS
Dimensions*
Volume*
lt. 59
ENERGY LABEL
e
ECODESIGN
Dimensions**
Volume**
lt. 62
width 43.5 cm
height 32.4 cm
depth 41.5 cm
width 45.5 cm
height 32,4 cm
depth 41.5 cm
voltage: 220-240V~ 50 Hz
maximum power absorbed 2800 W
EU Directive no 65/2014
supplementing Directive 2010/30/EU.
EU Regulation no 66/2014
implementing Directive 2009/125/EC.
Standard EN 60350-1
Standard EN 50564
Electrical
connections
Declared energy consumption for
Forced convection Class
-
heating mode
:
Conventional
This appliance conforms to the
following European Economic
Community directives:
- 2006/95/EC of 12/12/06 (Low
Voltage) and subsequent
amendments;
- 2004/108/EC of 15/12/04
(Electromagnetic Compatibility) and
subsequent amendments;
- 93/68/EEC of 22/07/93 and
subsequent amendments.
- 2002/96/EU and subsequent
amendments.
* Only for models with drawn rails.
** Only for models with wire rails.