Instruction for Use

User manual

CLEANING THE WATER FILTER / DRAINING RESIDUAL WATER

Switch o and unplug the washing machine before cleaning the water lter or draining residual water. If you used a

hot wash programme, wait until the water has cooled down before draining any water.

Clean the water lter regularly, to avoid that the water cannot drain after the wash due to obstruction of the lter.

Especially:

• if the appliance is not draining properly or if it fails to perform spin cycles.

• if the “Clean pump“ indication lights up.

1. Open the lter cover with a coin.

2. Container for the drained water:

Place a low and wide container under the water lter in

order to collect the residual water.

3. Drain the water:

Slowly turn the lter counter-clockwise until all the

water has come out. Allow the water to ow out without

removing the lter. Once the container is full, close the

water lter by turning it clockwise. Empty the container.

Repeat the procedure until all the water has been drained.

4. Remove lter: Lay a cotton cloth beneath the water lter,

which can absorb a small amount of rest water. Then

remove the water lter by turning it out anti-clockwise.

5. Clean the water lter: remove residues in the lter and

clean it under running water.

6. Insert the water lter and close the cover:

Reinsert the water lter again by turning it in clockwise

direction. Make sure to turn it in as far as it goes; the lter

handle must be in vertical position. Pour approximately one

litre of water into the washing machine via the drum and

check that water does not leak from the lter. Close the lter

cover.