User's Manual

14
EN
Water container
Condenser unit
Condenser cover
Catches
Filter
Handle
Air intake
Tap
Rear
Front
Condenser
unit
Care and maintenance
Disconnecting the power supply
! Disconnect the dryer when not in use or during cleaning
and maintenance operations.
Cleaning the filter after each cycle
The filter is a fundamental component of the dryer: its function
is to collect lint and fluff that form during drying.
Clean the filter once drying is completed, by rinsing it under run-
ning water or cleaning it with a vacuum cleaner. Should the filter
become clogged, the flow of air inside the dryer will be seriously
hampered: drying times becomes longer and more energy is
consumed. Moreover, the dryer may become damaged.
The filter is located in front of the dryer seal (see Picture).
Removing the filter:
1. Pull the filter’s plastic han-
dle upwards (see Picture).
2. Clean the fluff off the filter
and replace it correctly. En-
sure that the filter is pushed
fully home.
! Do not use the dryer unless
the filter has been replaced
in its holder.
Checking the drum after each cycle
Rotate the drum manually to remove smaller items (handker-
chiefs) that could have been left inside the dryer.
Cleaning the drum
! Avoid using abrasives, steel wool or stainless steel cleaning
agents to clean the drum.
A coloured film may appear on the stainless steel drum
surface: it may be caused by a combination of water and/or
cleaning agents such as wash-softeners. This coloured film
does not affect the dryer’s performance.
Emptying the water container after
each cycle
Remove the water container and empty it into a sink or other
suitable drain outlet, then replace it correctly.
Always check the water container and empty it before star-
ting a new drying cycle.
Cleaning the condenser unit
• Remove the condenser (see Picture below) unit regularly
(monthly) and clean off any fluff deposits from the plates
by rinsing it with COOL water running on the rear end of
the condenser.
Removing the condenser:
1. Disconnect the dryer from the power supply and open the
door.
2. Open the condenser cover (see Picture below), unlock the
three catches by turning them 90° anti-clockwise, then
pull on the grip to remove the condenser.
3. Clean the surface of the seals and replace the unit with
the arrows pointing upwards, while making sure that the
catches are securely fixed.
Cleaning the tumble dryer
• The external metal, plastic and rubber parts can be clea-
ned with a damp cloth.
• Clean the front air intake grille regularly (every 6 months)
with a vacuum cleaner to remove any lint, fluff or dust
deposits. Furthermore, remove any lint deposits from the
front part of the condenser and from the filter area, using a
vacuum cleaner every so often.
! Do not use solvents or abrasives.
! Have the dryer checked regularly by authorised technical
personnel in order to ensure that the electrical and mechani-
cal parts work safely (see Assistance).