Instructions for use WASHER-DRYER Contents GB English, 1 GB Installation, 2-3-4-5 Unpacking and levelling Electric and water connections The first wash cycle Technical details Washer-dryer description, 6-7 Control panel Display MEMO Programme Starting and Programmes, 8 Briefly: how to start a programme Programme table Personalisations, 9-10 WIDXE 146 S Setting the Setting the Setting the Setting the Functions spin cycle delay timer temperature drying cycle Detergents and laundry, 11 Detergent di
Installation GB Keep this instruction manual in a safe place for future reference. Should the appliance be sold, transferred or moved, make sure the instruction manual accompanies the washer-dryer to inform the new owner as to its operation and features. Levelling your appliance correctly will provide it with stability and avoid any vibrations, noise and shifting during operation.
Connecting the drain hose 65 - 100 cm Connect the drain hose, without bending it, to a draining duct or a wall drain situated between 65 and 100 cm from the floor; the supply voltage is included within the values indicated on the Technical details table (see page 5); GB the socket is compatible with the washer-dryer's plug. If this is not the case, replace the socket or the plug. Your appliance is now supplied with a 13 amp fused plug it can be plugged into a 13 amp socket for immediate use.
As the colours of the wires in the lead may not correspond with the coloured markings identifyng the terminals in your plug, proceed as follows: Connect Green & Yellow wire to terminal marked E or coloured Green or Green & Yellow. or Connect Brown wire to terminal marked L or coloured Red. Connect Blue wire to terminal marked N or coloured Black. If a 13 amp plug (BS 1363) is used it must be fitted with a 13 amp fuse, either in the plug or adaptor or at the distribution board.
GB Technical details Model WIDXE 146 S Dimensions 59.5 cm wide 85 cm high 53.5 cm deep Capacity from 1 to 6 kg for the wash programme; from 1 to 5 kg for the drying programme Electric connections please refer to the technical data plate fixed to the machine Water connections maximum pressure 1 MPa (10 bar) minimum pressure 0.05 MPa (0.
Washer-dryer description Control panel FUNCTION GB Buttons START/RESET button START/STOP button Display Control knob Detergent dispenser DRYING SPIN button button TEMPERATURE button DELAY TIMER button Detergent dispenser to add detergent and fabric softener (see page 11). Display to programme the Washer-dryer and follow the wash cycle progress (see opposite page). SPIN button to adjust the spin speed or exclude it altogether (see page 9). FUNCTION buttons: to select the functions available.
Display GB In addition to being a practical tool to programme your appliance (see page 9), the display provides useful information concerning the wash cycle. Once you have pressed the START/RESET button to start the programme, the display will indicate the amount of time left until the end of the wash cycle. If a delayed start has been set (using the Delay Timer, see page 9), the delay time will be indicated on the display.
Starting and Programmes Briefly: starting a programme GB 5. Select any functions (see page 10). 6. Add the detergent and any fabric softener (see page 11). 7. Start the programme by pressing the START/RESET button for one second. To cancel it, keep the START/RESET button pressed for at least 2 seconds. 8. When the programme has ended, the word END is displayed. Take out your laundry and leave the appliance door ajar to allow the drum to dry thoroughly. . 9. Turn the Washer-dryer off by pressing button 1.
Personalisations FUNCTION buttons Setting the spin cycle If, when the appliance is switched on, the KNOB is positioned on appears. Press button a programme with a spin cycle, a fixed and the maximum spin speed allowed for the programme set will be displayed, and the icon flashes. Press it again and the values lower until they reach OFF, which indicates that the spin cycle has been excluded (press it again to go back to the maximum value); stop on the desired speed, after approximately remains fixed.
Drying levels Iron : slightly damp clothes, easy to iron. Hanger : dry clothes to put away. Cupboard : very dry clothes, recommended for towelling and bathrobes. GB A cooling stage is foreseen at the end of the drying cycle. If your laundry load to wash and dry is exceptionally in excess of the maximum load foreseen (see table opposite), perform the wash cycle, and when the programme is complete, divide up the garments and put part of them back in the drum.
Detergents and laundry Detergent dispenser Special items Good washing results also depend on the correct dose of detergent: adding too much detergent won't necessarily make for a more efficient wash, and may in fact cause build up on the interior of your appliance and even pollute the environment. Curtains: fold curtains and place them in a pillow case or mesh bag. Wash them separately without exceeding half the appliance load. Use programme 5 which excludes the spin cycle automatically.
Precautions and advice The Washer-dryer was designed and built in compliance with the applicable international safety regulations. The following information is provided for your safety and should consequently be read carefully. GB General safety This appliance has been designed for nonprofessional, household use and its functions must not be changed. This washing machine should only be used by adults and in accordance with the instructions provided in this manual.
Care and maintenance Cutting off the water or electricity supply Turn off the water tap after every wash. This will limit the wear of your appliance's water system and also prevent leaks. Unplug your appliance when cleaning it and during all maintenance operations. Cleaning your appliance The exterior and rubber parts of your appliance can be cleaned with a soft cloth soaked in lukewarm soapy water. Do not use solvents or abrasives.
Troubleshooting Your washing machine could fail to work. Before calling for Assistance (see page 14), make sure the problem can't easily be solved by consulting the following list. GB 14 Problem Possible causes/Solution: The washing machine won't start. The washing machine does not fill with water (The wording H2O is displayed). The machine continuously fills and empties with water.
Service Before calling for Assistance: Check whether you can solve the problem on your own (see page 14); Restart the programme to check whether the problem has been solved; If this is not the case, contact an authorised Technical Service Centre on the telephone number provided on the guarantee certificate. GB If the machine has been installed or used incorrectly, you may be charged for the maintenance callout service. Always request the assistance of authorised servicemen.
195070489.