User Manual

ManualsBrandsInducore ManualsAircraftF3 FC for Micro FPV Drones w/ Built-in FrSky Receiver

BEECORE FRSKY F3_EVO_Brushed ACRO Flight Control Board quick user guide

This board is designed to work with Inductrix / BeeDuctrix / Tiny Whoop / Eachine E010, just replace the

current board with our new BEECORE main board and experience the next level of flight control.

1. Specification:

STM32 F303 processor

Six-Axis: MPU6500

Size: 2mm x 26mm

Weight: 3 grams

Work voltage: 3.7v-5v / 1S Lipo battery input

Receiver: 8CH Frsky protocol SBUS output D8 Mode

Firmware Version: Cleanflight 1.13.0

2. Connector and LED Definition:

Summary of content (4 pages)

PAGE 1
BEECORE FRSKY F3_EVO_Brushed ACRO Flight Control Board quick user guide This board is designed to work with Inductrix / BeeDuctrix / Tiny Whoop / Eachine E010, just replace the current board with our new BEECORE main board and experience the next level of flight control. 1. Specification: STM32 F303 processor Six-Axis: MPU6500 Size: 2mm x 26mm Weight: 3 grams Work voltage: 3.7v-5v / 1S Lipo battery input Receiver: 8CH Frsky protocol SBUS output D8 Mode Firmware Version: Cleanflight 1.13.0 2.
PAGE 2
3. Installation and Connection diagram： Please pay attention to the motor sequence of Inductrix main board , it’s different from BEECORE, Install the motor according to the diagram above. 4. Cleanflight / Betaflight configuration： All the configuration was set up before shipping, if you need to flash firmware and select Full chip erase, you should reconfigure for the BEECORE Flight controller board according to the bellowing diagram.
PAGE 3
2. Ports and receiver mode sets like the bellowing diagram: First Enable Seria_RX for uart2 and Set Receiver mode RX_SERIAL , Select SBUS signal in Cleanflight configurator. 3. Binding Procedure: a)Power for the BEECORE while Jumped the two “Bind” Pins, the LED Combo (2 Red and 2 White) will getting to be solid, this means the BEECORE is in binding mode. b)Turn on your Radio and select D8 mode for the Receiver. Then Go to the Receiver [Bind] option, and ENT to Binding with the BEECORE.
PAGE 4
. The default receiver channel map is TAER1234, please ensure your transmitter is matched with it, otherwise it can't be armed. 5. The Default Arm/Disarm switch is AUX1(Channel 5),and you can also customize it with Cleanflight Configurator or Betaflight Configurator. 6. Set Arm/Disarm switch for your TARANIS X9D: Move to the MIXER interface, Set “SA” or “SB” switch etc. for Ch5 to ARM/DISARM the motor. 7.