User's Manual

CAS-GPS Node II User Manual
CAS-GPS Node II User Manual (DOCU0142) Rev A Page 18 of 20
13 Regulatory Information
Warning: Modifications to this product without written consent from the manufacturer or its designated authorised
representatives could void the user’s authority to operate the equipment
13.1 Declaration of Conformity with FCC rules for electromagnetic compatibility
We, GE Digital Mining Technology, of 3 Co-Wyn Close, Fountaindale, NSW, 2258, Australia
declare under our sole responsibility the products:
MAKE: CAS-GPS NODE
FCC ID: YIY-PROD11162
MODELS: PROD1116-L2
PROD1116-E2
PROD1116-S2
PROD1116-P2
PROD1116-L2(X)
PROD1116-E2(X)
PROD1116-S2(X)
PROD1116-P2(X)
PROD1151
PROD1044
PROD1155
PROD1150
to which this declaration relates:
Complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
13.1.1 FCC Interference Statement for Class B devices.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
13.1.2 Federal Communication Commission (FCC) - Radiation Exposure Statement
To comply with FCC RF exposure limits for general population / uncontrolled exposure, the antennas used for this
transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter.