User's Manual

CAS-GPS Node II User
Manual
CAS-GPS Node II User Manual (DOCU0142) Rev D Page 10 of 21
9.2.1.1 Type S Node - Standby Mode
Standby Mode is a low power state which is activated shortly after the PDA has shutdown. A configurable amount of time (default
15 minutes) after the vehicle ignition has been switched off, the light vehicle display will be shutdown. A few minutes after that,
the CAS-GPS system will enter Standby Mode. The CAS-GPS system will return to full power operation once the vehicle ignition
has been switched on. In Standby Mode, the Nodes will operate as normal but transmit at a slower rate. They will also only
periodically reacquire a GPS lock.
9.2.2 PROD1116-Lν(X)(xx) - Light Vehicle Node
The Light Vehicle Node is suitable for a fixed installation on light vehicle types. The Light Vehicle Node can act as your primary
fleet monitoring radio in light vehicles where self-test functions are not required. As a secondary Node this product enables
automatic real-time functional health monitoring of a PROD1116-Ev(X)(xx) NODE without the requirement for a remote Test
Station or operator interaction. The Light Vehicle Node communicates with the CAS-GPS user interface via a Personnel Area
Network wireless connection and can be powered from a 12 or 24Vdc automotive supply. This model accepts 2 digital inputs for
ignition and reverse used for power management and directional orientation on your CAS-GPS user interface software.
9.2.3 PROD1116-Ev(X)(xx) – Light Vehicle Expandable Node
The Light Vehicle Expandable Node is suitable for a fixed installation on light vehicle types. The Light Vehicle Expandable Node
acts as your primary fleet monitoring radio in light vehicles and is suitable for connecting a secondary Node PROD1116-Lν(X)(xx)
on its output port. The Light Vehicle Expandable Node communicates with the CAS-GPS secondary Nodes via dedicated serial
data connections and can be powered from a 12 or 24Vdc automotive supply. Primary communication to the user interface is
via a Personal Area wireless connection. This model accepts 2 digital inputs for ignition and reverse used for power management
and directional orientation on your CAS-GPS user interface software.
Refer DOCU0146, CAS-GPS Light Vehicle MT Installation Manual for full installation instructions
PROD1116-Lv(X)(xx)
CAS
-
GPS LIGHT VEHICLE NODE
PROD1116-Ev(X)(xx)
CAS-GPS
LIGHT VEHICLE NODE