User's Manual

CAS-GPS Node II User
Manual
CAS-GPS Node II User Manual (DOCU0142) Rev D Page 12 of 21
9.3 CAS-GPS NODE OPERATION
9.3.1 On System Start-up
Immediately after starting the system and before putting it into service, perform a quick check of the CAS-GPS user interface
status ICONs. Check that none of the icons are Red indicating a fault condition, if so your CAS-GPS system is not functioning
correctly and its operation and your visibility within the fleet cannot be assured! The icon for the ToF Link will be disabled for
node variants without ToF ranging functionality.
Stationary Objects without a permanent display should have functions regularly checked on a temporarily paired CAS-GPS user
interface display as detailed in the installation manual for the stationary object.
Display
Battery Charge Status
Primary NODE
Battery Charge Status
Secondary NODE
Battery Charge Status
Primary NODE + Display
Link Status
Ignition Input Status
Primary + Secondary NODE
ToF Link & Self-Test Status
Primary NODE
GPS Status
Primary + Secondary NODE
V2V Link & Self-Test Status
Secondary NODE
GPS Status
Display
GSM/WCDMA Status
Display
Wi-Fi Status
Reverse Input Status
North
If any of the CAS Icons are red the system may not be operating correctly and the
fault must be reported for action to the fleet manager.
Depending on your system configuration at startup, the GPS will assume you are
facing 'North' until a heading has been established by forward movement. Heading
may be determined without forward movement when self-test functionality is
installed.
If a nearby vehicle’s beams are overlapping your vehicles beam an audible alarm
will be sounded within the CAS-GPS application. Only when your vehicle is stationary
may you silence the alarm by touching anywhere on the screen.