User's Manual

CAS-GPS Node II User
Manual
CAS-GPS Node II User Manual (DOCU0142) Rev D Page 13 of 21
9.3.2 Vehicle in Motion
When your vehicle is moving, you can operate using your normal safe operating procedures. The Display will sound an alarm
to gain your attention if there is another vehicle that is getting too close. A quick glance at the display will show the location,
type, ID, heading and speed of other vehicles.
9.3.3 Positional Tracking
The system uses the latest precision point GPS technology which gives accurate location-based tracking.
9.4 NODE STATUS INDICATOR LAMP
All Node variants will report their status via the multi-function lamp:
Node status
indicator
Indication Node Status
Off Off
Red Failed Battery
Amber Battery out of service temperature range
Green On, Not Charging
Alternating Green/Cyan* On, Charging
Cyan On, Fully Charged
Magenta Flashing
1 / 30 seconds
On, Standby Mode
Magenta
On. Acquiring new position in Standby
Mode
*In this mode the lamp will cycle between the two colors at approximately 1Hz
You cannot silence the alarm whilst your vehicle is in motion.
For the GPS to work accurately the Node must have clear line of sight to the sky.
Obstructions such as machine structure, work roof or deep pit may affect the accuracy
or operation of the GPS.