User's Manual

CAS-GPS Node II User

Manual

CAS-GPS Node II User Manual (DOCU0142) Rev D Page 8 of 21

5 STORAGE

Where the equipment is not to be installed immediately, proper storage is important to ensure protection of equipment and

validity of warranty.

All equipment should be stored indoors, protected from the elements in a cool dry area. If storing on the ground, ensure

that the storage area is not an area where water will collect.

The recommended temperature while in storage is -20

C to 60

6 UNPACKING OF EQUIPMENT

When unpacking the equipment:

 Check for damage during transit.

 Confirm that all the components required are present.

If the set of components received is incomplete or damaged contact WABTEC in a timely

way to minimize delays.

7 INSTALLATION

Installation should be in accordance with the vehicle manufacturers instructions, national regulations and the

installation procedures defined by Wabtec Digital Mining Technology. The installations must only be performed by

authorized and qualified installers.

8 TEST & COMMISSION

At installation time, the system must be checked against the installation test procedure (ITP) to verify the system is correctly

installed and functioning as required. After passing its final installation test, the system is then ready for use after which

inbuilt self- diagnostic testing combined with daily user monitoring ensures that any faults can be acted upon.

Take care when unpacking the equipment to avoid damage.