Instruction Manual

3.4 CONFIGURATION OF WEIGHING APPLICATION OPTIONS.
If you are using one of the weighing 'SPECIAL APPLICATION'
modes then the following must be configured:
Section 3.4.1
SELECT SCALE METER TYPE.
Section 3.4.2
CONFIGURE SCALE UNITS.
If pulse input is being used then also configure:
Section 3.4.3
DECIMAL POSITION.
Section 3.4.4
COUNT/PULSE FACTOR
.
The
'SPECIAL APPLICATION'
modes are selected by IDS152 by reading the
thumbwheel
switch on power up.
THUMBWHEEL
POSITION APPLICATION MODE
0 BASIC PRINTER MODE.
1 PRINT WEIGHT ONLY.
2 PRINT WEIGHTS WITH GROSS, AND TARE LABELS.
3 GROSS, TARE, NET PRINTING.
4 PRINT AND TOTAL.
5 PRINT, SUBTOTAL, AND TOTAL.
6 PRINT AND TOTAL ( AXLE WEIGH ).
7 WEIGH-IN, WEIGH-OUT.
If position 0
(BASIC MODE
) is used then ignore section 3.4.
The section 3.4 configurations have no effect in
BASIC MODE.
REMEMBER:
Return the thumbwheel switch to the correct mode
postition after configuration
.