Instruction Manual

IDS 430/433 Users Manual Version 1.0
- 18 -
# 1 Fill to Setpoint
Press the F1 key, the display prompts “SEt Pt” key in the setpoint value and
depress the Enter key. Place an empty container on the scale. Press the F2 key
to begin filling. TTL output 1 turns on until the weight on the scale is equal or
greater than the setpoint.
Connect TTL out put 1 to a relay to turn on motors, open and close gates, turn
on and off flow valves for automated filling or indication.
Installation
Connect TTL output 1 to relay or lamp actuator.
TB4 - Pin 1 = TTL output 1 (active low) +5volts idle, 0 volts active.
TB3 - Pin 1 = +5 volts
Setup Parameters:
(See chapter 6: Set Operation Parameters for setup details)
Parameter 43 Minimum scale weight to begin filling. Verifies that a container is
on the scale. Defaults to 0 = there is no minimum.
Parameter 44 Minimum fill amount. Defaults to 0. Set to some small value to
insure that a fill amount has been entered.
Parameter 45 Maximum fill amount. Default 5000. Maximum fill weight that will
ever be used.
Parameter 46 Scale empty weight. Default 50. Maximum weight to begin fill.
Verifies that an empty container is on the scale.
Operators Functions
Enter setpoint
Press F1 key to enter the setpoint. Enter the setpoint weight, then press the
ENTER key.
Start fill operation
Place the container on the scale (if required). Press F2 key to begin fill
operation.
Stop fill operations
Press the Clear key to stop fill operation.
Print Results
Press the Print key to print the Gross, Tare, and Net results of the fill operation.
Error Codes
Error 30 = Scale not empty
Error 31 = Minimum weight error: container is not on scale
Error 32 = Tare weight error: tare function failed, scale not stable (motion)
Error 33 = Setpoint less than minimum setpoint amount
Error 34 = Setpoint more than maximum setpoint amount