Instruction Manual

TABLE OF CONTENTS
INTRODUCTION
6
What’s in each section 7
Warranty Information 8
GENERAL DESCRIPTION
9
The IDS 430 Display and Keyboard Diagram 9
The IDS 430 Display 10
The IDS 430 Keyboard 10
INSTALLATION AND SETUP
11
Unpacking the IDS 430 11
Installation Guide /Safety Instructions 11
Setup Guide 13
NTEP Labeling Instructions 14
USING THE IDS 430
15
Keyboard Layout 15
Operation of Function Keys 16
Memory Registers Entry 16
Execute a scale Basic Function 16
Display time and Date 16
BUILT IN APPLICATION PROGRAMS
17
Select Mode of Operation (Parameter73) 17
Mode (1) Fill to Setpoint 18
Mode (2) Check-Weigh, Over, Under or Between 19
Mode (3) Weigh-In Weigh-Out 20
Mode (4) Axle weigh, Short Scale 22
Mode (5) Axle Weigh, Long Scale Unattended 23
Mode (6) ID, Tare and Total 24
Mode (7) Peak Hold 26
SET OPERATION PARAMETERS
27
Access Operation Parameters and Parameter Functions 27
Operation Parameter Reference Tables 28
Scale Parameters
31
Parameter 1. Load Cell m/V (3 m/V) 31
Parameter 2. Digital Filter (9) 31
Parameter 3. Display Update Rate (0) 31
Parameter 4. Motion Detection Delay (15) 32
Parameter 5. Motion Detection Band (6) 32
Parameter 6. Enable Display Blanking During Motion (no blanking) 32
Parameter 7. Zero tracking Delay (1) 32
Parameter 8. Zero Tracking Band (12) 32
Parameter 9. Push Button Zero Percent (100) 33
Parameter 10. Primary Units Type (1[lb]) 33
Parameter 11. Decimal Point Position (0[no decimal point]) 33
Parameter 12. Count–By (1) 33
Parameter 13. Alternate Units Type (2[kg]) 33
Parameter 14. Alternate Decimal Point (1) 34