User's Manual

Technical Document
430721-01
Rev. E
Indyme Solutions, Inc. 8295 Aero Place  San Diego, CA 92123 USA +1.858.268.0717  +1.800.829.6141 Page 3 of 7
After entering the Programming Menu;
Press the SET button once, RESET once. The assurance LED will flash once to confirm your entry. You are
now in Menu-1.
Enter your address as follows.
 Press the RESET button once to represent the zero. (0)
 Press the SET button once, RESET once to save. (1)
 Press the RESET button once to represent the zero. (0)
 Press the SET button seven times, RESET once to save. (7)
When the last digit is saved, the assurance LED will confirm your entry by flashing to indicate the digits entered.
A zero is indicated by a long flash of approximately 1-second.
Help button buttons-2-4 are automatically assigned the next consecutive alarm numbers. They cannot be
programmed independently.
Menu-2: Learn Mode –used to capture, (Learn) the Netcode from another GSF device that is in Clone Mode;
help button or access point.
After entering the Programming Menu;
Press the SET button twice, RESET once. The assurance LED will flash twice to confirm your entry. You
are now in Menu-2.
The transmit LED will begin flashing ¼-sec ON, 1-sec OFF. This indicates that the help button is
requesting a Netcode. When the help button receives a Netcode, the transmit LED will flash rapidly for
approximately 3-seconds, and then exit Learn Mode. If the help button does not receive a Netcode
within 5-minutes, the help button will exit Learn Mode.
Menu-3: Global Input Mode -used to assign operational characteristics to all inputs globally. The operational
characteristics define how the help button will respond to button presses, input triggers and timing parameters.
After entering the Programming Menu;
Press the SET button 3-times, RESET once to save.
The assurance LED will flash three times to confirm your entry. You are now in Menu-3.
Press the SET button <1--6> times to select the Operating Mode, RESET once to save.
The assurance LED will flash to confirm your entry.
Menu-7: Clone Mode –used to send the Netcode to another GSF device.
After entering the Programming Menu;
Press the SET button seven times, RESET once. The assurance LED will flash seven times to confirm your
entry. You are now in Menu-7.
The assurance LED will flash a cadence of 4-ON, pause, 4-ON, pause, etc, to indicate it is in Clone Mode.
To exit press the RESET button. The help button will stay in Clone mode for 5-minutes or until the RESET
button is pressed. Insure you are using a help button that is already working with the installed system.
To Clone using an access point see the CB951 installation document.
Menu-11: Individual Input Mode -used to assign operational characteristics to each input individually. The
operational characteristics define how the help button will respond to button presses, input triggers and timing
parameters.
After entering the Programming Menu;
Press the SET button 11- times, RESET once to save.
The assurance LED will flash eleven times to confirm your entry. You are now in Menu-11.