Technical. Doc CB440/CB5H Installation And Programming Instruction or have an advisory message: Location Considerations Call boxes are generally best located at areas that require assistance to access store merchandise, such as high shelving, chain and rope culling, key machine, efc. Stores and installers should be aware of Americans With Disabilities Act (ADA) requirements for accessibility. The:call boxes utilize a very. low powered transmitter, and. operate best with-a clearing of sight to.
Press the RESET button when finished: with the tens digit: Press button: 1 to increment fhe ones digit, LED 1 will inf with each press. Rags the RESET button when finished with the ones digit: “The address just programmed should flash back on the LED t with a pause. between each digit: (Note! the LED will indicate a zero value by staying ond on a Longer period of time, approximately: 1 second). ° BN IPI Power: must be installed JPA Pulse Width: must be tats Aaron during call box programming.
INDY ME Technical. Document CB475 Installation And Programming Instruction Individual caliber addresses shooting be determined prior to starting Gall box installations. As programmed call box defalcates to an addressee 001; this positioning the control unit may be k or have an advisory message.
INDY ME Technical. Document CB475 Installation And Programming Instruction individual caliber addresses should be determined prior to starting call box installations.
DYE Technical Document 5. Install the signs (if not already installed) into the sign extrusion. Install the top and bottom caps: 6. Install the call box by sliding it over the brackets. Position: the bottom of the caliber Fish with the Sower edge of the bottom bracket, Verity the red antenna wire (from the PCA inside the call box) is routed up the back, inside of the sign blade. 7. Firmly tighten the Slotted hex-washer head screw.with a nut-driver. The.
INDY ME Technical Document 9. The address dust programmed should flash back on the LED: 1 with a. pause. Between sate digit. (Note: the LED will indicate a zero value by staying on fora longer period of time, approximately 1 second). JPY Power! must be installed. JP4 Pulse Width: must be installed for. Narrow, during call box programming. Pulse Width operation and program 4 Sh Call Box PEA Bas cot Berating modes as defined: in TENON: axes Fol nation.
CB514 Installation And Programming Instruction Individual biblical. addresses should be determined prior to starting the installations. As deprogramming calf box defaults to:an address of 001, this position in the contort unit may by blank or. have an advisory message. Location. Considerations Director call boxes are generally best located thigh volume areas that demand 8 way to request additional services quickly, stitch as front registers or service counters.
Technical Document Press the RESET button when finished with the tens digit. Press button 1:10 increment the ones digit. LED: 1-wiki flash with each press: Press the RESET bisector when finished with the donas digit: 9. Thai address just programmed should flash back on the LED 1 with a pause between each digit: (Note: the LED will indicate a zero value by staying on fora longer period of time, approximately 1.