User's Manual

Indyme Solutions, Inc. 8295 Aero Place  San Diego, CA 92123 USA +1.858.268.0717  +1.800.829.6141Page 2 of 7

Technical Document

430696-00

Rev. J

GSF Help button Programming

GSF Help buttons function in the 800MHz ʹ 900MHz frequency spectrum. These wireless transceivers,

communicate with the CB951 Access Point. Each help button MUST be programmed with the correct

parameters to match the CB951 Access Point(s). Help buttons use a hierarchy based menu structure.

You must enter the Programming Menu first, to select the desired submenu. Each submenu may have

one or more options available. These options are used to assign specific operational characteristics to

the help button. Review the submenus/options before you begin programming. The submenus/options

will vary by help button model.

Enter the Programming Menu

Press and hold the RESET button until the assurance LED flashes one time.

Press and hold the SET button, until the assurance LED flashes two times.

Press and hold the RESET button, until the assurance LED flashes three times.

The help button is now in the Programming Menu mode, proceed to the desired submenu. (***)

Menu-1: Address Programming

Assigns the help button to a corresponding alarm event programmed in the control unit. A help button

address is a four digit number from 0001 to 4095. Leading zeros are required.

After entering the Programming Menu;

Press the SET button one time for Menu-1, RESET once to save.

The assurance LED will flash one time to indicate Menu-1 was selected.

Use SET and RESET to program the 4-digit address as follows;

SET = digits 1-9, RESET = digit 0 and SAVE. Leading zeros are required

For example, program Alarm-0802 as follows:

 Press RESET once to represent the zero. (0)

 Press SET eight times, RESET once to save. (8)

 Press RESET once to represent the zero. (0)

 Press

SET two times, RESET once to save. (2)

Note: When the RESET button is pressed to save the 4

digit, the assurance LED will flash to indicate the

address that was entered. The assurance LED will indicate digit zero by a long flash. (approximately 1-

sec.)

Programming

Address Learn Operation Clone Frequency

Menu-1 Menu-2 Menu-3 Menu-7 Menu-8