User's Manual

Technical Document

Indyme Solutions, Inc. 8295 Aero Place  San Diego, CA 92123 USA +1.858.268.0717  +1.800.829.6141 Page 5 of 6

Wall Mounting

1. Identify the desired mounting height for the SET ďƵƚƚŽŶƚǇƉŝĐĂůůǇϰϴʹ ϱϰŽĨĨƚŚĞĨůŽŽƌ

2. Align the mounting plate at that height and selected orientation.

3. If mounting to glass or a smooth non-porous surface, use the double-sided adhesive ONLY. If mounting

to a solid surface or drywall, mark and drill through the two mounting holes.

4. Insert mounting hardware in the two holes and secure the mounting bracket.

a. wall anchors and screws if drywall or masonry

b. screws only for wood.

5. Position the cover over the assembly and gently press it down until it snaps into place.

6. From the final mounting location, press the SET button on the help button and verify the

appropriate message is broadcast over the desired output device

After the mounting plate has been

installed, the cover can be installed.

Place the cover over the mounting

plate aligning the hooks to the left,

then slide the cover to the right while

applying pressure until the cover

snaps into place.