User's Manual
Technical Document
<Tag Here>
Indyme Solutions, Inc. 8295 Aero Place San Diego, CA 92123 USA +1.858.268.0717 +1.800.829.6141Page 3 of 7
Menu-2: Call Box Learn Mode
Allows the call box to capture the Netcode from another GSF device; (call box or access point). All call
boxes and access points must have the same Netcode to communicate.
After entering the Programming Menu;
Press the SET button two times for Menu-2, RESET once to save.
The LED will flash twice to indicate Menu-2 was selected.
The LED will then begin flashing. ¼ second on, 1 second off. This indicates that the call box is
requesting a Netcode. When the call box receives a Netcode, it will flash the assurance LED
rapidly for approximately 3 seconds and then it will exit Menu-2. If no Netcode is received
within 5 minutes, the call box will exit Menu-2.
Menu-3: Call Box Operating Mode
Assigns the call box operating characteristics; timeout duration, RESET signal and number of active
buttons. Although set at the call box, the Operating Mode can be reset and overridden by the control
unit. Operating Modes will vary by call box type, below are the default modes for this call box.
After entering the Programming Menu;
Press the SET button three times for Menu-3, RESET once to save.
The assurance LED will flash three times to indicate Menu-3 was selected.
Press the SET button to select a Call Box Operating Mode: <1, 2, >, RESET once to save.
The assurance LED will flash to indicate the selected Operating Mode.
Mode 1 - 1-Button Call Box 8-min timeout, No Reset
Press any channel button to trigger the alarm state; the corresponding LED(s) will flash. The
LED will flash for 8 minutes, then extinguish with no reset sent. The RESET button will sent a
reset signal for all active channels.
Mode 2 - 1-Button Call Box 30-sec timeout, No Reset
Press any channel button to trigger the alarm state; the corresponding LED(s) will flash. The
LED will flash for 30 seconds, then extinguish with no reset sent. The RESET button will sent
a reset signal for all active channels.
Menu-7: Call Box Clone Mode
Allows the call box to broadcast the Netcode to other GSF call boxes. All call boxes and access points
must have the same Netcode to communicate.
NOTE: GSF Call Boxes will NOT go into Clone Mode if it is programmed to Netcode-00000001*
After entering the Programming Menu;
Press the SET button seven times for Menu-7, RESET once to save.
The assurance
LED will flash seven times to indicate Menu-7 was selected.
The assurance LED will now flash a cadence of 4-pause, 4-ƉĂƵƐĞĞƚĐ
The call box will stay in Clone mode for 5-minutes or until the RESET button, is pressed.