Installation & Assembly

1. The Paris, Dublin, and Rouen model faucets require a

1-⅜” diameter faucet hole. The Niagara model

faucets require a 1-¾” diameter faucet hole.

Position your faucet and check the position from the

sink before drilling.

2. Screw on the 2 bolts to the bottom of the faucet.

Remove the nuts if they are on the bolts. If you have

a thick countertop, the bolts only need to be

inserted about ¼” and can be loose – when the nuts

are attached, it will tighten down.

3. Secure the hoses to the bottom of the faucet. DO

NOT HAND SCREW THEM ON – be sure to use a

wrench and do not twist the steel braids as this will

damage the hoses and cause leaks.

4. Place the rubber ring under the faucet base. Place

the faucet on top of the faucet hole with the hoses

and bolts running through the hole.

5. Place the rubber plate then metal plate to the

bottom of the countertop with the bolts going

through the 2 holes. Secure them with the nuts.

6. Attach hoses to water supply - left hose to hot, right

hose to cold.

Inello Faucet

Installation Instructions

Thank you for your purchase. Below are instructions for Inello faucets. Model body may vary. Please

read the instructions before installing. Always measure before drilling or cutting. We are not responsible

for mis-drilled holes or cuts.

PAGE 1
Inello Faucet Installation Instructions Thank you for your purchase. Below are instructions for Inello faucets. Model body may vary. Please read the instructions before installing. Always measure before drilling or cutting. We are not responsible for mis-drilled holes or cuts. 1. The Paris, Dublin, and Rouen model faucets require a 1-⅜” diameter faucet hole. The Niagara model faucets require a 1-¾” diameter faucet hole. Position your faucet and check the position from the sink before drilling. 2.
PAGE 2
Inello Faucet Installation Instructions Thank you for your purchase. Below are instructions for Inello faucets. Model body may vary. Please read the instructions before installing. Always measure before drilling or cutting. We are not responsible for mis-drilled holes or cuts. 1. The Paris, Dublin, and Rouen model faucets require a 1-⅜” diameter faucet hole. The Niagara model faucets require a 1-¾” diameter faucet hole. Position your faucet and check the position from the sink before drilling. 2.