User Manual

8 - 4
IPN 074-289L
Composer Operating Manual
8.2.3.3 Set Up Process Parameters
Once you have set up the communications parameters,
1 Go to the Setup >> Process Parameters.
2 Click on the Get button to read the parameters stored in the Composer.
NOTE: You may want to save these parameters as the factory defaults. This
can be done through the Settings-File >> Save As menu item.
This dialog is structured to read a Composer’s parameters by clicking on the
Get button or to download the displayed set of parameters to the controller by
clicking on the Send button. The parameters can be altered by placing the
cursor within the appropriate parameter’s data field and modifying them. If any
particular field is not relevant, it is grayed out. When complete, click the Send
button to download the parameters into the Composer.
Parameter sets may be saved and opened via the Settings-File >> menu item.
For a description of each parameter and its allowed range, see section 8.3.5 on
page 8-14.
NOTE: This application cannot read or modify the switch setting of either
CFGR1 or CFGR2. Particularly important is SW#7 on CFGR1. When it
is ON, it locks the parameters and will not allow any of the downloaded
parameters to be accepted. In addition, when SW#5 on CFGR2 is OFF,
Composer will ignore the Dilution Flow parameters.