Manual

2 - 22
IPN 074-517-P1D
Guardian Co-Deposition Controller Operating Manual
If the SQM-242 card is installed properly, Card: 2.XX, DLL: OK is displayed. If you
are using a Q-pod, its serial number appears. Verify that each sensor attached to
the QCM displays a frequency reading on the main screen.
2.4.6 Digital I/O
The I/O tab of the Edit System dialog box assigns the Guardian controller's relays
and digital inputs to program functions. See Figure 2-22. Most digital I/O is not
necessary for initial operation. Consult Chapter 3 for I/O programming, Chapter 4
for I/O wiring.
Figure 2-22 I/O Tab
2.5 Operation
This section assumes that you have worked through the example process of
section 2.2 on page 2-1 and the initial detector calibration of section 2.3 on page
2-5.
2.5.1 Build a Single Layer Process
Build a simple single-layer, single-film process in the EIES program and make it the
active process (refer to section 2.2 on page 2-1). Verify that the EIES channel you
are using has no errors, and shows a reading near zero (refer to section 2.3 on
page 2-5).