Install Instructions

Infinet Wireless: Technical Documentation – InfiMAN Evolution
18 https://wiki.infinetwireless.com/display/DR/RF
19 https://wiki.infinetwireless.com/display/DR/MINT
20 https://wiki.infinetwireless.com/display/DR/MINT
21 https://wiki.infinetwireless.com/display/DR/RF
22 https://wiki.infinetwireless.com/display/DR/Network+Settings
Operation & Administration – 102
•
•
•
•
62 Figure - PRF settings
"Join" subsection
In the "Join" subsection, you can link two or more radio/pseudo-RF
18
interfaces of one unit into oneMINT
19
domain.
Each of these interfaces may act as an independentMINT
20
network node. The "Join" subsection is available for
configurations only after at least one pseudo-RF
21
interface has been created in "Network Settings
22
" section.
In order to join the interfaces, simply enable the check boxes of the corresponding interfaces, as shown in the
screenshot below:
63 Figure - «Remove» and «Add Join» buttons
7.3.4 Static Links
In the "Static Links" section, you can set up fixed links to the unit. Although the radio parameters and security key
match with other nodes, the node that has Static Links set up is only linked with the nodes which are configured in
this section. The parameters are:
"MAC"- MACaddress of the neighbor unit
"Key"- link security key (up to 64 characters long, without spaces).
Another two options are available:
Disable the link by marking the option “Disabled" in the corresponding checkbox
Add a linkdescription in the “Note" field