Install Instructions
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
Installation – 52
AUX-ODU-LPU-L Mounting
AUX-ODU-LPU-Lis installed on a mast, using clamp. Attach the grounding cable (min cross-section 2.5 mm
2
) to the
case, using grounding bolt.
12 Figure - AUX-ODU-LPU-L Mounting
During AUX-ODU-LPU-L mounting it is necessary to provide a small loop of the FTP cable that should be below the
cable gland. This ensures that water is not constantly channeled towards the connector. It will also serve as a cable
compensation for the cable linear expansion as the temperature difference result.