Product Info
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
20 https://wiki.infinetwireless.com/display/DR/Link+aggregation%2C+balancing+and+redundancy
21 https://wiki.infinetwireless.com/pages/viewpage.action?pageId=43827596
Operation & Administration – 109
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
MINT Failover Activate the failover function on this interface. For more information
about this function proceed to the article "Link aggregation,
balancing and redundancy
20
"
21
If the MAC address of a neighbor is specified, then the device will
monitor the availability of this address. If the MAC field remains
empty - the neighbor's address will be determined automatically
Current Settings
Channel Width Set the bandwidth of the radio interface in MHz
It must be the same at both ends of the link
Frequency Set the radio interface frequency (in MHz)
It must be the same at both ends of the link
If it is set to “Auto”, the Slave node is scanning on all frequencies for
the Master nodes
Frequency Range List Set the frequencies that are allowed to be chosen by
theDFSmechanism (available only when theDFS system is enabled)
It is available to support the legacy products
Note that this option is different from the "Customer Frequency Grid"
tool which allows narrowing down the frequency range available in
the "Frequency" option from the Radio profile
Tx Bitrate Set the maximum operating bitrate of the radio interface
Acts as a top limit for the bitrate if the Autobitrate mechanism is
turned on
By default, it is turned on (it is strongly recommended to remains
“on”)
Adjust the Autobitrate system thresholds when the
remoteSNRdoesn’t have the normal level
Channel Type The channel type can be set as:
Dual: enablesMIMOoperational mode with different Tx and Rx
data streams (recommended)
Single: allows to operate asMIMOwith duplicate Tx
streams,MISOorSISOdepending on the Tx/Rx chain
configuration (description below)
NetworkSID Set the network system identifier (up to 8-digit HEX figure)
It must be the same at both ends of the link