Product Info
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
22 https://wiki.infinetwireless.com/display/DR/MIMO
23 https://wiki.infinetwireless.com/display/DR/SISO
Operation & Administration – 112
Rx
Activated Activated
Tx
Activated Activated
16 Table - Settings for MISO mode
Settings for"SISO"mode
The data streams are transmitted over Chain #0 (corresponding to vertical polarization) only, lowering the
performance of the link, but increasing the link distance (transmitter operates with one antenna as does the
receiver; there is no diversity and no additional processing for recomposing the Rx signal):
Channel
Type
Single
Radio Chain #0 #1
Rx
Activated Deactivated
Tx
Activated Deactivated
17 Table - Settings for SISO mode
The picture below summarizes the link establishment between two units that are configured in different
operational modes. As it can be noticed, only the combinationMIMO
22
–SISO
23
is not functional.
61 Figure - Radio link establishment
7.3.3.2 "prf" subsection
In the "prf" subsection, you can configure the pseudo-RFlink as aMINTnetwork node. The "prf" subsection is
available for configurations only after at least one pseudo-RFinterface has been created in "
Network Settings(see
page 97)" section. Pseudo-RFvirtual interface is used to provideMINT-over-Ethernet.
EveryBSorCPEsupportsPRFinterfaces. All parameters available in "prf" subsection are explained in"rf6.0"
subsection(see page 0)above: