Product Info

Infinet Wireless: Technical Documentation – InfiMAN Evolution
44 https://wiki.infinetwireless.com/pages/viewpage.action?pageId=10780956
45 https://wiki.infinetwireless.com/pages/viewpage.action?pageId=42274923#mintcommand(TDMAversion)-RemoteCommandManagement
46 https://wiki.infinetwireless.com/pages/viewpage.action?pageId=17597370
Troubleshooting – 158
•
•
•
•
•
•
•
•
•
96 Figure - Spectrum analyzer
Command line interface
The radio environment analysis is also available via the command line using the "
muffer sensor
44
" command.
8.3 The wi reless link is established, but there is no access to the
remote device
Configuration analysis(see page 158)
Filtering rules(see page 159)
Checking the switch settings on the remote device(see page 159)
Device management(see page 159)
Checking the members of the switch group(see page 159)
Switch statistics(see page 160)
Checking the switch settings on the local device(see page 160)
Device management(see page 160)
Filtering rules(see page 160)
8.3.1 Configuration analysis
In the web interface go to the section "Device status" → "Link statistics on rf6.0 interface", then left-click on the
device to which the access is missing.Select "Remote commands".
97 Figure - Remote commands
In the pop-up window enter "config show". If the devices are configured via telnet, access to the remote device can
be obtained with the"mint rf6.0 rcmd
45
" command.
8.3.1.1 "Vlan" interfaces
Make sure that the "vlan" interfaces are configured in accordance with the company's security policy(see point 1 in
the figure below). The VLAN configuration process using the command line is described in the"
VLAN
configuration
46
" article.