Product Info

Infinet Wireless: Technical Documentation – InfiMAN Evolution
51 https://wiki.infinetwireless.com/display/DR/switch+command#switchcommand-Managementcommands
52 https://wiki.infinetwireless.com/display/DR/Remote+management+of+the+R5000+units
Troubleshooting – 160
•
•
•
•
•
•
•
•
•
•
8.3.2.3 Switch statistics
To display statistics about the dropped/blocked MAC addresses for each switch group, use the"
switch statistics
51
"
command.
100 Figure - Switch statistics
8.3.3 Checking the switch settings on the local device
8.3.3.1 Device management
Make sure that the switch group ID assigned for management on the local device matches with the switch group ID
on the remote device.Make sure that the rf6.0 interface has been added to the switch group. The svi interface must
be associated with the switch group and its IP address is used for the management of the device.For detailed
information about the device management configuration proceed to the"
Remote management of the R5000
units
52
" article.
8.3.3.2 Filtering rules
Pay attention to the traffic filtering rules in the switch group and in the"IPFirewall" subsection.Make sure that the
traffic from the remote device is not restricted.
8.4 The w ireless link thro ughput is lower than expected
Performance tests(see page 160)
Wireless link status(see page 161)
Link statistics on the rf6.0 interface(see page 161)
Radio statistics(see page 162)
QoS statistics(see page 163)
Statistics graphs(see page 163)
Device status(see page 164)
Last reboot reason(see page 164)
System log(see page 164)
Antenna alignment(see page 165)
8.4.1 Performance tests
Web interface