Product Info
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Synchronization unit
- // 0) { /* For each inline-commented element clear data-ref and class */ for (var i=0; i < commentedElements.length; i++) { commentedElements[i].dataset.ref= ""; commentedElements[i].className = ""; } } /* Else do nothing */ } }); //]> AUX-ODU-SYNC Mounting
- AUX-ODU-SYNC Cable gland Assembling
- AUX-ODU-SYNC Connection to ODU
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – InfiMAN Evolution
Link Pre-configuration in the lab – 47
•
•
•
•
•
Step 2:Access to the device
Let's access each unit to the default IP address 10.10.10.1 with mask 255.255.255.0 via a web browser. Before, make
sure the Ethernet port of the Laptop has anIP address assigned from the same subnetwork as the one for the unit
(e.g., set 10.10.10.10 with mask 255.255.255.0).
Use any letters or numbers for the initial authentication on each unit, for example:
Login: login.
Password: password.
After the first login, let's configure a distinctive name for each unit and set a custom login and password.Go to the
Basic Settings section, then to System Settings and configure::
Device Name (e.g., Master/Slave).
User Name (e.g., admin).
Password (e.g., admin).
NOTE
We assume that each unit used in this setup has not been configured before and runs with the factory
settings.
NOTE
We strongly recommend to change your login and password after the first login.