Datasheet

ManualsBrandsINFINEON TECHNOLOGIES ManualsPMICsPMIC - ELCs High side TO 220

September, 12th 2011

Automotive grade

AUIPS6031(S)(R)

www.irf.com

Done please find

INTELLIGENT POWER HIGH SIDE SWITCH

Features

 Over temperature shutdown (with auto-restart)

 Short circuit protection (current limit)

 Reverse battery protection (turns On the MOSFET)

 Full diagnostic capability (short circuit to battery)

 Active clamp

 Open load detection in On and Off state

 Ground loss protection

 Logic ground isolated from power ground

 ESD protection

 Lead Free and RoHS compliant

Description

The AUIPS6031(S)(R) is a five terminal Intelligent Power

Switch (IPS) for use in a high side configuration. It features

short circuit, over-temperature, ESD protection, inductive load

capability and diagnostic feedback. The output current is

limited to the Ilim value. The current limitation is activated until

the thermal protection acts. The over-temperature protection

turns off the device if the junction temperature exceeds the

Tshutdown value. It will automatically restart after the junction

has cooled 7°C below the Tshutdown value. The reverse

battery protection turns On the MOSFET. A diagnostic pin

provides different voltage levels for each fault condition. The

double level shifter circuitry will allow large offsets between

the logic and load ground.

Product Summary

Rds(on) 60m max.

Vclamp 39V

I Limit 16A

Open load 3V / 0.55A

Packages

TO-220 D²Pak D-Pak

AUIPS6031 AUIPS6031S AUIPS6031R

Typical Connection

Control

Rin

Load

+Bat

Input Signal

V Diag

Rdgs

Pull-up resistors required for

open load off and short

circuit to Vbat detection

Rdgp

+5V

Out(5)

Dg(4)

Vcc(3)

In(2)

Gnd(1)

Summary of content (17 pages)

PAGE 1
September, 12th 2011 Automotive grade AUIPS6031(S)(R) Done please find INTELLIGENT POWER HIGH SIDE SWITCH Features           Product Summary Over temperature shutdown (with auto-restart) Short circuit protection (current limit) Reverse battery protection (turns On the MOSFET) Full diagnostic capability (short circuit to battery) Active clamp Open load detection in On and Off state Ground loss protection Logic ground isolated from power ground ESD protection Lead Free and RoHS compliant Rds(o
PAGE 2
AUIPS6031(S)(R) Qualification Information† Qualification Level Moisture Sensitivity Level Automotive †† (per AEC-Q100 ) Comments: This family of ICs has passed an Automotive qualification. IR’s Industrial and Consumer qualification level is granted by extension of the higher Automotive level.
PAGE 3
AUIPS6031(S)(R) Absolute Maximum Ratings Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. All voltage parameters are referenced to Ground lead. Tj= -40°C..150°C, Vcc=6..35V (unless otherwise specified). Symbol Parameter Vout Voffset Vin Vcc max. Vcc cont. Vcc sc. Iin max. Idg max.
PAGE 4
AUIPS6031(S)(R) Static Electrical Characteristics Tj=-40°C..150°C, Vcc=6..
PAGE 5
AUIPS6031(S)(R) Protection Characteristics Tj=-40°C..150°C, Vcc=6..28V (unless otherwise specified), typical values are given for Vcc=14V and Tj=25°C Symbol Ilim Tsd+ TsdVsc UV+ UVVOL Off I OL On Parameter Internal current limit Over temperature high threshold Over temperature low threshold Short-circuit detection voltage(2) Under voltage protection Vcc going up Under voltage protection Vcc going down Open load detection threshold Open load detection threshold Min. Typ. Max.
PAGE 6
AUIPS6031(S)(R) Functional Block Diagram All values are typical VCC 165°C Tj 37V Charge Pump 158°C 43V Vcc-gnd >UV 2.5V 6V 150k IN Level Shifter 43V Driver 2.0V Over-temp + I sense I Limit Open load off + DG 6V Short circuit 3V + 3V Open load on Ground Disconnect + 20mV GND www.irf.
PAGE 7
AUIPS6031(S)(R) T clamp Vin Vin Iout limiting Thermal cycling Ilim Ids Tj Vcc Tsd+ Tsd- Vds DG Vds clamp See Application Notes to evaluate power dissipation Figure 1 – Active clamp waveforms Figure 2 – Protection timing diagram 90% Vin Dg Vcc 10% Tr-in In Gnd Vclamp Out + 14V - L Vcc 90% Vcc-5V 5V Vout Vin 0V 10% Td on Td off Tr1 Tf Vout Rem : During active clamp, Vload is negative R Iout Tr2 Figure 3 – Switching times definitions www.irf.
PAGE 8
AUIPS6031(S)(R) 200% 600 400 Eon 200 Eoff 0 0 2 4 6 8 10 Rds(on), Drain-to-Source On Resistance (Normalized) Eon, Eoff, switching energy (µJ) 800 150% 100% 50% -50 Iout, Output current (A) 0 50 100 150 Tj, junction temperature (°C) Figure 5 – Switching energy (µJ) Vs Output current (A) Figure 6 - Normalized Rds(on) (%) Vs Tj (°C) 100 20 TO 220 5°C/W Ids, cont. Output current (A) Iout, Output current (A) D2Pak 40°C/W 10 1 0.001 10 5 0 0.01 0.
PAGE 9
AUIPS6031(S)(R) 20 10 I limit (A) Zth, transient thermal impedance (°C/W) 100 1 10 0.1 0.01 1e-5 0 1e-4 1e-3 1e-2 -50 1e-1 1e+0 1e+1 1e+2 1e+3 0 Time (s) 100 Tj, junction temperature (°C) Figure 10 –I limit (A) Vs junction temperature (°C) Figure 9 – Transient thermal impedance (°C/W) Vs time (s) 1.E+4 Icc on/ Icc off, supply current (µA) 1.E+4 Icc on/ Icc off, supply current (µA) 50 1.E+3 Icc on Icc off 1.E+2 1.E+1 1.
PAGE 10
AUIPS6031(S)(R) Case Outline - TO220 (5 leads) www.irf.
PAGE 11
AUIPS6031(S)(R) Case Outline D2PAK - 5 Leads www.irf.
PAGE 12
AUIPS6031(S)(R) Tape & Reel D2PAK - 5 Leads www.irf.
PAGE 13
AUIPS6031(S)(R) Case Outline DPAK - 5 Leads www.irf.
PAGE 14
AUIPS6031(S)(R) Tape & Reel DPAK - 5 Leads www.irf.
PAGE 15
AUIPS6031(S)(R) Part Marking Information Ordering Information Base Part Number Standard Pack Package Type Complete Part Number Form AUIPS6031 AUIPS6031S AUIPS6031R www.irf.
PAGE 16
AUIPS6031(S)(R) IMPORTANT NOTICE Unless specifically designated for the automotive market, International Rectifier Corporation and its subsidiaries (IR) reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue any product or services without notice.
PAGE 17
AUIPS6031(S)(R) Revision History Revision Date B C www.irf.