User's Manual

InfiNet Wireless R5000 Technical User Manual

“Run Tests”/”Stop Tests” buttons at the bottom of the page start/stop the

performance tests.

“Back” button returns to the “Device Status” page.

Each row corresponding to a certain bitrate value can be selected or deselected

for participating in the performance test by using a check-box on the right of it.

By using “Select all” check-box all the bitrates could be selected/deselected at

once.

Three more parameters are available for management:

• “Bi-directional” check-box that allows choosing between making bi-

directional (when checked) and unidirectional (unchecked) performance

tests.

• “Use mint” check-box allows performing MINT-enabled test when all the

traffic and link parameters are controlled and managed by MINT

functions such as ATPC and autobitrate. In this mode the statistics for

errors abd retries is not available.

• “Test time” parameter allows setting the duration of the test for each

bitrate in seconds (5 seconds by default).

The bitrates list on the “Performance test” page consists of the bitrates that

corresponds to the channel bandwidth set on the unit (5/10/20/40MHz). To

perform the tests for the bitrates related to the other channel bandwidth you

need to reconfigure channel bandwidth (“Channel Width” parameter in the

“Radio Setting” section of the “Basic Settings” page) on both units that form the

tested link.