User's Manual

InfiNet Wireless R5000 Technical User Manual

 DFS – allows starting DFS (Dynamic Frequency Selection) service or DFS

without Radar Detection

 Frequency - central operating frequency in MHz. Must be equal at both

sides of the link.

 Frequency range list - list of frequencies allowed for choosing by DFS

service

 Tx Power - output power of the radio in dBm. ―Auto‖ field enables the

ATPC function (recommended).

The ATPC Correction field make the ATPC function set higher (―+‖

number in dB) or lower (―-‖ number in dB) power levels compared to the

value it has estimated by itself.

 Tx Bitrate - fixed operating bitrate (if numerical value chosen) or auto

bitrate (Automatic Modulation Control) if "Auto" is chosen

(recommended).

The Autobitrate Correction field make the Autobitrate function increase a

bitrate (―-‖ number in dB) even if the signal level is lower by the

specified number of dB than that required. Or keep the bitrate down

(―+‖ number in dB) until the signal level becomes higher by the specified

number of dB than that required.

Advanced Radio Settings

This subsection of the ―Radio Settings‖ section allows managing the signal chains

of the radio module and creating a customized frequency grid.

―Antenna #0‖ and ―Antenna #1‖ Rx/Tx checkboxes enables/disables receive and

transmission modes of the corresponding signal chain of the unit‘s radio module.