User's Manual

InfiNet Wireless R5000 Technical User Manual

To enable SNMP functionality on the units and configure SNMP access

parameters the ―Access‖ subsection of the ―SNMP‖ section is used. SNMP

Versions 1 and 3 are supported.

To start SNMP services on the unit check the ―Start SNMP‖ check-box.

SNMP Version 1 Configuration:

The ―Version 1 enable‖ check box enables/disables SNMP Version 1 support. The

―Community‖ field sets a community name for the SNMP Version 1 agents. The

default community name is "public".

The optional ―Contact‖ and ―Location‖ fields enable adding information about the

unit‘s owner and location.

SNMP Version 3 Configuration:

To add a new SNMP Version 3 user press ―Add SNMP v3 User‖ button. Then fill in

the following parameters in the appeared fields:

 User Name – sets the SNMP Version 3 user‘s name.

 Password – sets the user‘s password for the authentification. Should

contain at least 8 characters.

 Security – sets an SNMP Version 3 security level as follows:

o No Authentification No Privacy – SNMP messages are sent

unauthenticated and unencrypted.

o Authentification No Privacy – SNMP messages are sent

authenticated and unencrypted.

o Authentification and Privacy – SNMP messages are sent

authenticated and encrypted. The passphrase for the encryption

can be set in the ―Privacy Password‖ field. The encryption

protocol can be chosen in the ―Privacy Protocol‖ drop-down field.

 ―Readonly‖ check-box – if checked permits only to read the variables. If

unchecked permits Read-Write operations.

 ―Admin‖ check-box – if checked provides full access to the variables. If

unchecked gives only limited access.

 ―Remove User‖ button removes the user from the SNMP configuration.

Several users can be added to the SNMP configuration.

To display help on the SNMP configuration parameters use the ―Help‖ button.