User's Manual

Hereby, InfiNet Wireless declares that this equipment is in compliance with the essential requirements

and other relevant provisions of Directive 1999/5/EC.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant

to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications.

Important statements

Changes or modifications not expressly approved by the party responsible for compliance could void the

user‘s authority to operate the equipment.

This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated outdoor with a minimum distance of 2

meters between the radiator and the human body.

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)

this device must accept any interference, including interference that may cause undesired operation of

the device.

R5000-Omx model has been designed to operate with the antennas listed below having a maximum gain

of 28 dBi. Antennas not included in this list or having a gain greater than specified above are strictly

prohibited for use with this device. Antennas allowed to use are as follows:

• Mars Antennas MA-WA56-DP25N – 23 dBi directional antenna (point-to-point operation only)

• Mars Antennas MA-WA56-DP28 – 28 dBi directional antenna (point-to-point operation only)

• Mars Antennas MA-WD56-DP16 – 16 dBi 90 deg sector antenna (point-to-multipoint operation)

The required antenna impedance is 50 Ohms.

This equipment must be professionally installed. The installer shall be responsible for verifying that the

correct antenna is employed with the unit.