User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Introduction– 15
•
•
•
•
3.4.2.4 Gigabit Ethernet Port
RJ-45 socket for connecting to power supply and network via the PoE power supply.The network connection to the
ODU is made via a 1000Base-T (Gigabit) Ethernetconnection. Power is provided to the ODU over the 1000Base-T
Ethernet connection usinga standard IEEE 802.3atpassive PoE power supply.
3.4.2.5 LED Panel
The "POWER" indicator has three possible colors:
Red light - the device is connected to the electricity mains,
Yellow light - a wired connection with a speed of 10/100 Mbps
Green light - a wired connection with a speed of 1000 Mbps.
Other indicators are used to perform coarse antenna alignment. The more indicators are on, the better wireless
connection is established. The blinking indicator means an intermediate state.
3.4.3 Part number description
Quanta 5 /Quanta 6part number has the following structure
Structure items are described below
Item Description
1 Product family name:
Q- Quanta.