User Manual
Table Of Contents
- About This Manual
- Important Notice
- Introduction
- Document structure
- Document marks
- Key Features
- Hardware Platform
- Power supply
- Lightning protection unit
- Packing List
- Planning considerations
- Link Pre-configuration in the lab
- Installation
- Operation & Administration
- Web GUI Access
- Dashboard
- Device status
- Wired interface
- Wireless link status
- Modulation code scheme
- Modulation and coding schemes are selected independently for each channel (uplink and downlink) for both polarizations. Current modulation for each channel is displayed in the MCS subsection.
- Received signal strength indicator
- EVM
- Retries and Frame loss
- General settings
- Security settings
- Radio settings
- Network settings
- Switch Settings
- SNMP settings
- Spectrum Analyzer
- Antenna Alignment Tool
- Maintenance
- Instant DFS
- Troubleshooting
- Glossary
Infinet Wireless: Technical Documentation – Quanta 5 / Quanta 6
Introduction– 19
•
•
•
•
•
•
•
•
•
•
•
•
•
Parameter Description
Connectors and Interfaces "ETH IN" - Ethernet input (Data only)
"ETH OUT" - Ethernet output (Data+VDC), PASSIVE PoE
"PWR" - AC Input
Supported Ethernet Modes 10/100/1000Mbps
Input Power Requirements AC Input Voltage: 100 ... 240 VAC
AC Input Current: 0.4A @ 100 VAC
AC Frequency: 50 to 60 Hz
Consumption 15,4 W (Guaranteed)
Operating temperature range -10 °С ... +50 °С
Operating humidity Maximum 95 %, Non-condensing
Storage temperature -40°С... +85°С
Storage humidity Maximum 95 %, Non-condensing
Output Power Voltage 48 VDC
Ethernet Connectors Pin-out
ETH IN ETH OUT
Pin Description Pin Description
1 Data pair A+ 1 Data pair A+
2 Data pair A- 2 Data pair A-
3 Data pair B+ 3 Data pair B+
4 Data pair C+ 4 +VDC + Data pair C+
5 Data pair C- 5 +VDC + Data pair C-
6 Data pair B- 6 Data pair B-
7 Data pair D+ 7 -VDC + Data pair D+
8 Data pair D- 8 -VDC + Data pair D-